A S S E M B LY I N S T R U C T I O N S Wilmington Vinyl Screen Kit 2 Pack (36”W x 48”H) Zippity DO-IT-YOURSELF FRIENDLY PRODUCTS 36 in 11 2 in 3 in 4 1 in 2 1 in 181 2 in 48 in 11 2 in 181 2 in 7 in 8 Ground 32 in 4 in 10 in 333 8 in If necessary, this enclosure can be trimmed down horizontally and vertically to fit your custom space. Use a fine toothed circular or hack saw. Rails will need to be re-spaced and configured accordingly Ver 1.
G E N E R A L I N F O R M AT I O N Zippity DO-IT-YOURSELF FRIENDLY PRODUCTS Please read through before starting assembly. IMPORTANT: CHECK THE INSIDE OF THE LARGER PIECES IN YOUR BOX FOR OTHER MATERIALS PACKED INSIDE. Check Box for These Contents In the event of missing or defective parts please call our customer service department at 1 877 234 6196 (Mon. to Fri. 8:00 AM to 4:00 PM EST). 1. 2. 3. 4. 5. 6. 7. Post Caps (4) Top and Bottom Rails (4) - 1½” x 1½“ x 36½” Posts (4) - .
1 STEP ONE Holes for Vertical Slats Only on One Side 1 Identify the top and bottom rails (rails with holes on only one side for vertical slats) 2 Position the two posts as illustrated and slide the top rail (with holes facing up as illustrated) down over the posts until the pre-drilled holes in rails are aligned with the pre-drilled holes in both posts.
STEP T WO 1 Slide the bottom rail (same as the top rail) over the posts and begin aligning vertical slats one by one into the bottom rail. 2 Align the pre-drilled holes on the rail with the pre-drilled holes in the posts and fasten with screws on both sides of post.
STEP THREE 1 Install Screen into Ground 1 Move the screen to its final location and identify the location of posts. 2 Attempt to push the unit into the ground as illustrated Optionally: 1. If your ground is too hard, loosen the top 6” or 7” of the ground with a claw hammer as illustrated. 2. Add water to loosened soil 3. Use a block of wood to the protect the top of post and gently hammer the post into the ground.
STEP THREE Install Screen into Ground (Continued) 3 Level the screen as necessary and backfill excavated dirt and tamp as necessary. 3 Level If your ground is really hard, you may need to dig a hole large enough to accomodate one post from each panel into the same hole - Approximately 8” in diameter and 10” deep. Backfill and compact the dirt.
STEP FOUR Fasten Joiner Clips 1 Fasten screens together by using joiner clips as illustrated. 2 Fasten the opposite end of the joiner clip as illustrated.
STEP FIVE Fasten Post Caps 1 Push the post caps down over the posts to lock into place. 1 Zippity DO-IT-YOURSELF FRIENDLY PRODUCTS 8 www.zippity-outdoor.
