Use and Care Manual

ManualsBrandsUnbranded ManualsCamping Cookware2-in-1 Portable Gas Camping Stove Burner and Griddle with Integrated Igniter and Drip Tray

Left

Windshield

Grill Grate

Griddle

Wire Leg

Drip Tray

Wire Leg

Regulator

Stove Control

Knob

Stove Control

Knob

Piezo Igniter Button

Burner

Bottom Case

Right

Windshield

Lid

GENERAL SAFETY INFORMATION

• Use only 1 lb. (0.45 kg) propane gas cylinders marked USDOT-39 or

TC CAN/CSA B339.

• Use propane gas only.

• Use only the regulator included with your stove. Do not attempt to alter regulator.

• Do not use or attempt to use the stove as a heater.

• Stop operating stove if:

- Flames repeatedly go out.

- Combustion becomes unstable.

- Lighting cannot be performed easily.

- The temperature drops below -10°F.

- No fuel remains in the gas cylinder.

• Caution: Let the stove cool off for 15 minutes when ﬁnished with it.

SAFETY PRECAUTIONS

WARNING! Please read and understand all safety precautions, assembly

instructions, and care/maintenance instructions before operating this appliance.

Failure to properly follow the guidelines established here could result in severe

injury, ﬁre or even death. Keep this manual for future reference.

• Use the unit outdoors only.

• Turn off gas supply at the gas cylinder after use.

• Never operate this appliance without a regulator.

• Do not modify this appliance.

• Make sure gas hose is not near or touching the appliance.

• Use in well-ventilated areas.

• Keep appliance away from children. Never let children operate the unit.

• Always use protective gloves when handling hot components.

• If you smell gas, shut off the appliance immediately.

• Carbon Monoxide Hazard: This camping oven can produce carbon

monoxide that is odorless, colorless, and can cause death in a matter of

minutes. Do not use camping oven in enclosed space.

• Do not use appliance if it is damaged or has a leak.

• Make sure seals are secure and in good condition before operating

this appliance.

ASSEMBLY INSTRUCTIONS

1. Remove the appliance from the packaging and place the stove on a

hard, flat surface.

• Unfold wire legs down under the appliance.

• Open the lid upward to a vertical position.

• Unfold the windshields so they are in a vertical position.

• Connect the clips on the lid to the slots on the windshields.

2. Lift the grill grate and remove the regulator from its storage.

• Check the O-rings for any damage before connecting the regulator.

• Connect the regulator to the stove by inserting the end of the

regulator into the inlet connector on the side of the stove. Tighten the

attached nut on the regulator securely.

PARTS OVERVIEW

• The surface of the appliance will be hot when in operation. Handle with care.

• Ensure the appliance is placed on a flat, level surface. Do not move it when in use.

• Never test for gas leaks with a match or open flame.

• Do not perform any physical activities near appliance.

• Do not leave unit unattended when it is in use.

• Do not place or store any clothing or other miscellaneous items on top of or

against this device.

• Do not place or store chemicals, aerosol sprays, or other flammable items

near this device.

• Do not operate this appliance in a boat, trailer, or tent.

• Do not attempt to operate this device if any panels, covers, or safeguards

have not been properly installed.

• Ensure that the appliance is 40" or more away from any combustible materials.

• Never store the appliance while propane gas cylinder is still connected.

• Make sure all packaging is completely removed and properly disposed of

prior to first using this device.

• Always be sure to disconnect gas cylinder and store it safely in an area that

is well-ventilated and free from exposure to direct sunlight, heat, and any

ignition sources (pilot lights, matches, lanterns, etc.). If you choose to store

the propane gas cylinders indoors, make sure that the location complies with

any local regulations and standards pertaining to indoor propane gas storage.

• If the appliance can’t be adjusted to function properly, then it should not be

used until it is serviced or repaired.

• This appliance should only ever be repaired or serviced by an authorized

serviceperson. Do not attempt to repair this unit on your own.

• Do not attempt to fit other types or sizes of gas containers or tanks to this

device, as this could prove hazardous.

• Only use this appliance in well-ventilated areas. It should only be operated in

an above-ground, open-air situation where there is natural ventilation, no

stagnant areas, and where gas leakage and/or products of combustion will

be promptly diffused by wind and natural convection.

• Never attempt to pick up or move the appliance while it is in operation.

Always extinguish the burner, allow the device to cool down, disengage the

gas cylinder, and then move it.

• You must use this appliance with the approved gas regulator that came with

it. Do not use a different gas regulator or any kind of adapter.

Dual Burner Stove

with Griddle

USER GUIDE

HC1B1FWI

Thank you for purchasing the Hike Crew™ Dual Burner Stove with Griddle.

This User Guide is intended to provide you with guidelines to ensure that

operation of this product is safe and does not pose risk to the user. Any use

that does not conform to the guidelines described in this User Guide may

void the limited warranty.

Please read all directions before using the product and retain this guide for

reference. This product is intended for household use only. It is not intended

for commercial use.

This product is covered by a limited one-year warranty. Coverage is subject

to limits and exclusions. See warranty for details.

PACKAGE CONTENTS

• Dual burner stove with griddle

• User guide

Summary of content (2 pages)

PAGE 1
GENERAL SAFETY INFORMATION • • • • • • • Use only 1 lb. (0.45 kg) propane gas cylinders marked USDOT-39 or TC CAN/CSA B339. • Use propane gas only. • Use only the regulator included with your stove. Do not attempt to alter regulator. • Do not use or attempt to use the stove as a heater. • Stop operating stove if: - Flames repeatedly go out. - Combustion becomes unstable. - Lighting cannot be performed easily. - The temperature drops below -10°F. - No fuel remains in the gas cylinder.
PAGE 2
STARTUP 3. Check that the stove control knobs are in the OFF position. Connect the gas cylinder to the regulator and hand tighten firmly. 4. Once the burner is ignited, use the stove control knob to increase or decrease flame intensity. NOTE: Each burner can be operated independently. Both burners do not need to be ignited at the same time. Lighting the Burner 1. Select the burner to be ignited. Turn the stove control knob almost fully counter-clockwise to start the flow of gas. 2.