Use and Care Manual

16
www.AQUASUREUSA.com
818 N Mountain Ave #203c, Upland, CA 91786 | 800.661.0680 | [e-mail]
1. Turn on the feed water adapter valve and
cold water supply valve to allow the water to
pass through. (See Diagram J-1)
2. Turn on the FLOWLOK™ valve to allow the
water to enter the system. (See Diagram J-2)
3. Turn on the Tank Ball Valve lever parallel to
the tubing connection to allow the water to
enter the tank. (See Diagram J-3)
4. Wait 2 to 3 hours for the water storage tank
to ll. The system will automatically shut off
once the tank is full.
5. Check for leaks! The system is now lled
with water and pressurized.
6. Drain out the rst tank of water by turning
on the dispensing faucet. Have the water
run till it becomes a slow stream of water, or
when it starts to trickle. (See Diagram J-4)
STEP 7. System Startup
WARNING! Immediately shut off the cold water supply valve or main water supply valve if there are
leaks. Check the leak area and see if there’s a loose connection or if more Teon tape is needed to
prevent leaks from happening.
Dia. J-1
Dia. J-2
Dia. J-3
Dia. J-4