Instructions / Assembly

ManualsBrandsUnbranded ManualsEvaporative Cooler AccessoriesUp-Dux 14 in. x 7-1/4 in. Evaporative Cooler Ceiling Vent

STANDARD HEIGHT MODEL with ADR™

PARTS LIST

QTY Description

1 Vent Sleeve w/ hinged Damper Lid

4 “L” Shaped Mounting Clips

1 Ceiling Grille

1 Slide-in Therma-Panel™

4 ¼” Mounting Clip Screws

2 ½” Grille Mounting Screws

IMPORTANT:

 AS DESCRIBED BELOW, UP-DUX

VENT MUST BE SUPPORTED IN THE CEILING BY ITS FOUR MOUNTING CLIPS AND SHOULD NOT BE

ATTACHED TO CEILING JOISTS OR FRAMED IN. PRODUCT MALFUNCTION ATTRIBUTABLE TO IMPROPER INSTALLATION MAY NOT BE

CLAIMED UNDER 90-DAY LIMITED WARRANTY.

 GARAGE INSTALLATIONS ARE NOT

CODE-APPROVED.

 MINIMUM ATTIC CLEARANCE OF 12” REQUIRED FOR INSTALLATION OF STANDARD HEIGHT (7 ¼”) MODELS.

 CEILING INSULATION HEIGHT MUST NOT EXCEED 6 INCHES.

 A SLIDE-IN THERMA-PANEL™ IS INCLUDED WITH EACH UP-DUX® VENT. THIS THERMA-PANEL™ SHOULD ONLY BE USED DURING PERIODS

WHEN THE EVAPORATIVE COOLER IS NOT IN OPERATION.

 THE CEILING GRILLE AND THERMA-PANEL™ MAY BE CLEANED WITH A MILD DETERGENT IN COOL WATER.

 REQUIRES SUFFICIENT ATTIC VENTILATION. FOR MORE INFORMATION SEE “UP-DUX

ATTIC VENTILATION RECOMMENDATIONS”

AVAILABLE AT www.dialmfg.com

(Technical).

CAUTION:

Do not attempt to adjust or change the position of the two ADR™ (Automatic Damper Release) panels. These ADR™ panels are spring loaded and – within the

range of normal temperatures – are held open by single-use fusible links.

The fusible links, identifiable from outside the vent by their red color, are anchored through the vent sleeve panels. By design, the vent will automatically respond

to abnormally high/emergency-level temperatures by closing its internal dampers – thereby blocking air flow through the vent to and from the attic. Once closed,

resetting requires replacement of the fusible links and push-nut fasteners, available on request from Dial Manufacturing, Inc.

www.dialmfg.com

Form 97651-0210

Summary of content (2 pages)

PAGE 1
STANDARD HEIGHT MODEL with ADR™ PARTS LIST QTY Description 1 Vent Sleeve w/ hinged Damper Lid 4 “L” Shaped Mounting Clips 1 Ceiling Grille 1 Slide-in Therma-Panel™ 4 ¼” Mounting Clip Screws 2 ½” Grille Mounting Screws IMPORTANT:        AS DESCRIBED BELOW, UP-DUX® VENT MUST BE SUPPORTED IN THE CEILING BY ITS FOUR MOUNTING CLIPS AND SHOULD NOT BE ATTACHED TO CEILING JOISTS OR FRAMED IN. PRODUCT MALFUNCTION ATTRIBUTABLE TO IMPROPER INSTALLATION MAY NOT BE CLAIMED UNDER 90-DAY LIMITED WARRANTY.
PAGE 2
Up-Dux® Ceiling-to-Attic Exhaust Vent - Installation Instructions (Standard Height Model) PLEASE READ THE FOLLOWING INSTRUCTIONS IN THEIR ENTIRETY BEFORE STARTING INSTALLATION.  Select installation location for Up-Dux® vent. For best air circulation, vent should be placed diagonally away from incoming air register(s) and 18” to 24” away from outer house wall (depending on the pitch of the roof).