Installation Guide

ManualsBrandsUnbranded ManualsWall Panels661457

Reversible Plywood Beadboard

RevBead

patent pending

• Acclimate in the installation environment for a minimum of 48 hours.

• Mark and cut on the backside of the panel to ensure a smooth edge.

• Please note and follow fastening schedule based on your application.

• Drywall is not a suitable backing and will not hold fasteners.

• Installation requirements can vary from jobsite to jobsite. These are our recommendations for installing

RevBead

and

PatriotBead

™

• Our warranty only covers panel failure due to delamination. Please see full panel warranty for additional information.

Before you start your plywood beadboard panel installation, it is important to note the following points contained

in these Installation Recommendations:

Birch Plywood Beadboard

Pine Plywood Beadboard

PatriotBead

U.S. Patents

8,414,996 and

9,242,391

™

Installation Recommendations

Summary of content (4 pages)

PAGE 1
RevBead ® patent pending Reversible Plywood Beadboard PatriotBead Birch Plywood Beadboard Pine Plywood Beadboard U.S. Patents 8,414,996 and 9,242,391 ™ Installation Recommendations Before you start your plywood beadboard panel installation, it is important to note the following points contained in these Installation Recommendations: • Acclimate in the installation environment for a minimum of 48 hours. • Mark and cut on the backside of the panel to ensure a smooth edge.
PAGE 2
Installation Recommendations for Walls and Ceilings: Panel Preparation: • Care should be taken during handling and storage of panels in order to prevent damage to shiplap edges, face, or back. • Acclimate in the installation environment for a minimum of 48 hours. Do not expose panels to direct weather or sunlight during the acclimation period.
PAGE 3
Panel Fitting & Installation for wall paneling/wainscoting applications: • Make the necessary cut-outs for doors, windows, electrical outlets, heat registers, etc. • Begin your installation by loosely fitting the panel into the starting corner leaving a ¼” expansion gap at the top and bottom of the wall and an 1/8” expansion gap around all cut-outs. Mouldings and/or outlet covers will conceal all expansion gaps.
PAGE 4
Panel Fitting & Installation for ceiling applications: • Make the necessary cut-outs for ceiling fixtures such as lights, fans, etc. • Begin your installation by loosely fitting the panel into the starting corner leaving a ¼” expansion gap where the walls meet the ceiling and an 1/8” expansion gap around all cut-outs. • The leading panel edge must correctly align with the center line of the trusses/rafters/joists to ensure all subsequent panels line up correctly during the balance of the installation.