Installation Guide
Parts List
PART NUMBER
UP168S (SURFACE)UP168I (IN GROUND)UP168F (FOOTING)DESCRIPTION
206522111
SIT-UP / BACK EXTENSION
206699111
BASE COVER
206467010FOOTBUCK WELD ASSEMBLY
206759020
SUPPORT FOOTBUCK WELD ASSEMBLY
206829001
206830010
206828100
135038*
020
1/2" ANCHOR ROD
801533*0403/4" x 2" HEX HEAD CAP SCREW
206358*
400
3/4" WEDGE ANCHOR
817354*4443/4" LOCKWASHER
800082*
400
1/2" x 4 1/4" WEDGE ANCHOR
800000*00
4
1/2" ANCHOR BOLT
800001*
004
3/4" ANCHOR BOLT
801207*0
4
01/2" x 2 1/2" Hex Bolt
804055*
048
1/2" HEX NUT
804058*0
4
83/4" HEX NUT
817342*
444
1/2" LOCKWASHER
817415*0
4
85/8" S.S. FLAT WASHER
817420*
048
3/4" FLATWASHER (2" O.D.)
HARDWARE COMPLETE
HARDWARE COMPLETE
HARDWARE COMPLETE
Issued/Revised:
08/29/13
UP168F SIT-UP/BACK EXTENSION (FOOTING)
FitTech
800.458.5872
www.actionfitoutdoors.com 1
ActionFit
UP168I SIT-UP/BACK EXTENSION (IN GROUND)
UP168S SIT-UP/BACK EXTENSION (SURFACE)
*Items listed below Hardware Complete line are included with Hardware Complete Number
Warning: During Installation, Hardware And Small Parts Are Choking Hazards For Young Children. Store
Unused Parts Appropriately Until Assembly Is Completed. Once Assembly Is Completed, Remove Any
Unused Parts From The Play Environment And Dispose/Save Them In A Secure Location. Any bolt end
protruding more than two full threads beyond the face of the nut causes risk of clothing entanglement.
Promptly cut-off flush, file smooth, and treat to prevent corrosion.
Unless Otherwise Specified, All Units of Measure are Each
Note: Peen Tee-Nuts and Flatwashers to match radius of pipe after assembly is complete.
Note: Loctite (supplied by others) should be used on any non-patch hardware.