QUICK START GUIDE 1000 Series • 115 V / 60 Hz
QUICK START GUIDE u-line.com WELCOME TO U-LINE Congratulations on your U-Line purchase. Your product comes from a company with over five decades of premium modular ice making, refrigeration, and wine preservation experience. U-Line continues to be the American leader, delivering versatility and flexibility for multiple applications including residential, light commercial, outdoor and marine use.
QUICK START GUIDE u-line.com This Quick Start Guide covers the basics of installation and general use of your product. For more details, see the complete User Guide & Service Manual on u-line.com. Contents 1. Safety and Warning 2. Environmental Requirements 3. Electrical 3. Door Swing 4. Door Adjustments 8. General Installation 9. Integrated Panel Installation 11. Control Operation 13.
QUICK QUICK START START GUIDE GUIDE u-line.com u-line.com Safety and Warning ! DANGER NOTICE This unit contains R600a (Isobutane) which is a Please read all instructions before installing, flammable hydrocarbon. It is safe for regular operating, or servicing the appliance. use. Do not use sharp objects to expedite defrosting.
START GUIDE GUIDE QUICK START u-line.com u-line.com Environmental Requirements OUTDOOR UNITS This unit is designed to operate between 50°F (10°C) and 115 V UNITS 100°F (38°C). Higher ambient temperatures may reduce This model is intended for indoor/interior applications only the unit’s ability to reach low temperatures and/or reduce and is not to be used in installations that are open/ ice production on applicable models. exposed to natural elements.
QUICK QUICK START START GUIDE GUIDE u-line.com u-line.com Electrical Door Swing ! WARNING Wall Wall 1/4" Min. (6 mm) 2-1/8" Min. (54 mm) SHOCK HAZARD — Electrical Grounding Required. Never attempt to repair or perform maintenance on the unit until the electricity has been disconnected. Never remove the round grounding prong from the plug and never use a two-prong grounding adapter.
START GUIDE GUIDE QUICK START u-line.com u-line.com Door Adjustments DOOR ALIGNMENT AND ADJUSTMENT 15” Models These general instructions apply to all models. For further details, see user guide for your specific model at u-line.com. Align and adjust the door if it is not level or is not sealing properly. If the door is not sealed, the unit may not cool properly, or excessive frost may form in the interior.
QUICK START START GUIDE GUIDE QUICK u-line.com u-line.com 3. Remove door by tilting forward and lifting door off 2. Remove magnet assembly from door with T-10 TORX bottom hinge. Retain shoulder washers; they will driver. Be sure to only remove the two screws holding be reused. the assembly to the door. Reinstall on the opposite end of the door 4. Remove three screws from hinge holes on the opposite side. Reinstall into holes where the hinge was 3.
QUICK QUICK START START GUIDE GUIDE u-line.com u-line.com TO ALIGN AND ADJUST THE DOOR 24” Models These general instructions apply to all models. For further details, see user guide for your specific model at u-line.com. Remove grille: Remove the grille (see GRILLE-PLINTH INSTALLATION section of this guide). 1. Loosen (do not remove) top and bottom hinge screws using a Torx T-25 screwdriver. 2. Align door squarely with cabinet. 3.
QUICK START START GUIDE GUIDE u-line.com u-line.com 3. Flip hinge plate over and reinstall on opposite side. Prepare door for reinstallation: 1. Remove gasket. This will reveal mounting holes for the magnet assembly 2. Remove plunger bracket from door with T-10 TORX driver. Be sure to only remove the two screws holding the assembly to the door. Reinstall on the opposite end of the door 3. Rotate gasket 180°, aligning notch with plunger bracket and pressing firmly into the gasket channel 3.
QUICK QUICK START START GUIDE GUIDE u-line.com u-line.com General Installation INSTALLATION 1. Plug in the power/electrical cord. 2. Gently push the unit into position. Be careful not to LEVELING INFORMATION entangle the cord. 1. Use a level to confirm the unit is level. Level should 3. Re-check the leveling, from front to back and side to be placed along top side. Make any necessary adjustments. The unit’s top edge and side edge surface should be approximately 1/8" (3 mm) below as shown.
QUICK START START GUIDE GUIDE QUICK u-line.com u-line.com Integrated Panel Installation Due to differences in floor construction or 1. Fully open door/drawer. flush with the top of the door/drawer. surrounding cabinetry, the panel may not sit 2. Starting at corner, pull Panel gasket away from door/ Door drawer. 3. Continue to pull gasket free from gasket channel. 9. Secure integrated panel to door/drawer 4. Upon removal, lay gasket Bar Clamp using clamps. A down on a flat surface.
QUICK START START GUIDE GUIDE u-line.com u-line.com 13.Be sure the screws force their way past the opening on the gasket channel and sit flush against the bottom of the channel. Integrated Panel Integrated Panel 14.Remove clamps from door/drawer. If panel requires additional adjustment after removing clamps, slightly loosen each screw and adjust panel as necessary. Tighten screws upon completion. 15.Starting at the corners, re-install the gasket into the gasket channel in the frame.
QUICK START GUIDE USER GUIDE u-line.com u-line.
QUICK START GUIDE USER GUIDE u-line.com u-line.
QUICK QUICK START START GUIDE GUIDE u-line.com u-line.com First Use All U-Line controls are preset at the factory. Initial startup requires no adjustments. NOTICE U-Line recommends allowing the unit to run overnight before loading with product. 1200 SERIES When plugged in, the unit will begin operating under the factory default settings. If the unit was turned off during installation, press and hold on.
U-Line Corporation (U-Line) Limited Warranty One Year Limited Warranty For one year from the date of original purchase, this warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase.
