Tools Adjustable Wrench(2) Teflon Tape « Groove Jolt Puller « Phillips Screwdriver « Silicone Sealant Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft, damp cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
Parts Diagram / List Port Name Handle Set Screw Handle Button {Red/Blue} Screw Escutcheon O-Ring Escutcheon Gasket Plaster Guard Tim Cap Lock Nut Cartridge Cartridge Cover Body Water Pressure Jo Int Stop Valve Core Spring O-Ring Stop Yale Core O-Ring Stop Valve Spout Shower Arm Flange Shower Arm Shower Head O-Ring Rubber Washer Allen Wrench is.
Preparation/Assembly . Note the installation dimension between shower arm, handle and spout. 101127 (267mm) 72-14NFT-2A (220mmy Wiy ey Min 127 (36mm-47mm) . If this is not a thin wall mounting, the plaster guard (#8) .> may be removed. % 8 Recommended 74” (1880mm) Minimum Floater Shower head, Or Greater A Eroded Note: Be sure the valve body is secured to the support cross board for stability. \\ . Apply Teflon tape on all pipe threads. Install elbow at one end. Connect other end to shower diverted.
Installation Instructions 5. Turn on hot and cold water supply lines. Turn on the faucet and let the water run from the tub spout for one minute to flush the debris from the line. If there is a leak, refer to correct section and repeat step. 6. Before installation, please slip flange (#22) onto the longer end of shower arm Wrap threads of the longer end of shower arm with Teflon tape and install shower arm.
Installation Instructions Adjusting hot water stop. Install escutcheon (#5) and secure with screws (#4) and o-ring Make sure valve is in off position. Note: Do not remove the customer service tag ° with the model number and phone number as Zfi 4 this will be helpful if you need assistance in . the future. 5 Assemble the handle (#1) on the escutcheon _ 4 L secure with the set screw (#2) and install the 14?3 handle button V Turn water on and check for leaks.
Troubleshooting If you've followed the instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Lockout [#10) has come loose of | Tighten the lock nut Clean or Leaks underneath handle. o-ring on cartridge dirty of | replace o-ring on cartridge twisted. Rubbermaid seat af the base of Remove handle and pressure balance Watermill not shun off completely. | pressure balance cor fridge {#11) cartridge {#11) to check the rubber is dirty or broken.
