User Manual

8
MODEL RT2000 (X2) USER MANUAL
INTRODUCTION
This section describes the basic operation of the terminal. The following topics are covered:
1. CONTROL PANEL LAYOUT. Describes the layout of the terminal’s control panel.
2. KEYPAD OPERATION. Describes the use of the function, alphanumeric (main), and on-screen keypads.
3. REAR SERVICE PANEL (RSP). Describes the RSP and its hardware.
4. MENU-BASED OPERATION. Gives a general overview of the terminal display interface.
5. CUSTOMER TRANSACTIONS. Summarizes the actions involved in typical customer transactions. In addition,
the voice-enabled transactions feature is described.
CONTROL PANEL LAYOUT
The user interface of the terminal consists of the LCD screen, receipt chute, card reader, speaker, headphone
jack (visually impaired), and 24 keys on three keypads. The Function keys are arranged in two four-key
groups, one group on either side of the LCD display. The main keypad consists of 10 alphanumeric keys,
two arrow keys and four large control keys, all located in a 16-key group beneath the LCD screen.
The main keypad and control keys have an integral raised Braille symbol to conform to the requirements of
the Americans with Disabilities Act (Figure 2-1).
Figure 2-1.
Control panel layout.
BACK LIT SIGN
FUNCTION KEYS
LCD SCREEN
MAIN KEYPAD
AUDIO JACK
CONTROL PANEL LIGHT
CAMERA A PERATURE
RECEIPT CHUTE
CARD READER
BILL TRAY