Model RL1600 QUICK REFERENCE GUIDE THIS AREA FOR SERVICE PROVIDER CONTACT INFORMATION: TDN 007103-00187 May 1 2009
0$1$*(0(17 )81&7,216 $&&(66 ,16758&7,216 $7 $70 :(/&20( 6&5((1 35(66 $1' +2/' '2:1 7+( &75/! .(< / 2:(5 5,*+7 &251(5 2) .(<3$' 35(66 ! .(< 7+(1 5( /($6( %27+ .
&/26( )81&7,216 )2//2: $&&(66 ,16758&7,216 72 (17(5 0$1$*(0(17 )81&7,216 6( /(&7 7(50,1$/ &/26( )81&7,216 '$< &/26( 7+,6 237,21 ,6 86(' 72 &203/(7( '$,/< %$/$1&,1* 2) 7+( $70 :,7+ 7+( 352&(6625 727$/6 $5( &/($5(' $1' 6:,7&+(' 72 7+( 1(;7 %86,1(66 '$< 75,$/ &/26( 7+,6 237,21 )81& 7,216 /,.
CASSETTE CLOSE FUNCTIONS FOLLOW ACCESS INSTRUCTIONS TO ENTER MANAGEMENT FUNCTIONS. SELECT TERMINAL CLOSE FUNCTIONS. SELECT CASSETTE CLOSE. n SELECT CASSETTE(S) TO CLOSE. A CHECK MARK ( ) IDENTI- q AFTER CASSETTE(S) HAVE BEEN REINSERTED IN THE DISFIES WHICH CASSETTE(S) ARE SELECTED. PRESS . PENSER, PRESS . r PLACE SELECTED CASSETTE(S) IN SERVICE. TER>. o A CLOSE REPORT IS DISPLAYED TO BE PRINTED OR SAVED.
REPLENISH MINI MECH CASSETTE STEP ACTION 1 UNLOCK/OPEN DISPENSER SECURITY DOOR. GRASP TRAY HANDLE AND REMOVE NOTE CASSETTE ACTION STEP 2 REMOVE 5 PLACE CURRENCY IN THE CASSETTE. 6 GRASP THE HANDLE AND SLIDE THE NOTE CASSETTE PACKER FORWARDS AGAINST THE NOTES. SLOWLY PUSH ANY REJECTED NOTES FROM THE REJECT COMPARTMENT. DO NOT RECYCLE REJECTED NOTES! 3 MOVE THE PUSHER PLATE TO THE REAR OF THE TRAY (TOWARDS THE HANDLE). 4 COUNT THE NUMBER OF BILLS THAT REMAIN IN THE CASSETTE, IF ANY.
REPLENISH RECEIPT PAPER NOTE: THIS PROCEDURE REQUIRES TERMINAL TO BE POWERED UP. STEP ACTION STEP 1 OPEN CONTROL PANEL. IF PAPER REMAINS ON ROLL, CUT OR TEAR PAPER BETWEEN ROLL AND PRINTER. 4 INSTALL NEW PAPER ROLL ONTO SPINDLE. 2 PRESS 5 INSERT PAPER/SPINDLE INTO PAPER BRACKET. PAPER FEEDS FROM TOP OF ROLL! 6 FEED END OF PAPER INTO PRINTER TAKE-UP SLOT. PAPER WILL FEED AUTOMATICALLY THROUGH THE PRINTER AND SLIGHTLY OUT FRONT OF UNIT.
COMBINATION LOCKS INTRODUCTION THE SECURITY CABINET CAN BE SECURED USING EITHER A MECHANICAL OR ELECTRONIC COMBINATION LOCK. THIS PAGE COVERS HOW TO OPERATE THE COMBINATION OF EITHER LOCK. TO CHANGE COMBINATIONS, SEE ATTACHMENT TO THE USER MANUAL. OPERATING THE MECHANICAL LOCK UNLOCKING THE LOCK THERE ARE TWO MARKS ON THE DIAL RING. THE INDEX AT THE TOP IS USED FOR OPENING THE LOCK, THE INDEX 30 DEGREES TO THE LEFT IS USED ONLY WHEN CHANGING THE COMBINATION.
