Owner Manual

TDN 07103-00162

HEATER UPGRADE PROCEDURE (MODEL RT2000)

TOOLS REQUIRED: Diagonal cutters, phillips-head screwdriver.

NOTE: If the unit is ON, enter MANAGEMENT FUNCTIONS > SYSTEM PARAMETERS > SHUT DOWN THE TERMINAL. When prompted on the

screen, turn the power switch on the power supply to the OFF (0) position.

Step 1:

ENSURE POWER SWITCH IS OFF! Using the diagonal

cutters, cut the ty-wraps that secure the AC power cables

near the power supply. Next, unplug all the AC power cables

from the power supply.

Power switch

Step 2:

Using a phillips screwdriver, remove the top screw that se-

cures the fan assembly cover. Next, remove the cover.

)0002TR(stiKedargpUylbmessAretaeH

)V511(12180-00260N/P

)V032(22180-00260N/P

rebmuNtraP noitpircseD ytitnauQ

28000-00290

)V511(,ylbmessAretaeH1

38000-00290

)V032(,ylbmessAretaeH1

40000-42620)mm021(,retliFnaF1

33070-02190rewoP,elbaC1

51000-27030parWyT3

33001

-00250noitallatsnI,DC1

12180-00260N/PtiknidedulcnI

22180-00260N/PtiknidedulcnI

PAGE 1
HEATER UPGRADE PROCEDURE (MODEL RT2000) NOTE: If the unit is ON, enter MANAGEMENT FUNCTIONS > SYSTEM PARAMETERS > SHUT DOWN THE TERMINAL. When prompted on the screen, turn the power switch on the power supply to the OFF (0) position. TOOLS REQUIRED: Diagonal cutters, phillips-head screwdriver.
PAGE 2
HEATER UPGRADE PROCEDURE (MODEL RT2000) Step 3: Step 6: Loosen the three (3) screws shown (yellow). Remove the screw in the lower right corner (blue). Note: This screw secures the ground wire lug. Retain this screw. Reinstall the heater assembly cover and secure on top with the screw previously removed. Step 4: Step 7: Remove the fan assembly (with its power cable). Install the new power cable provided to the heater assembly and the other end to the power supply.