Model RT2000 (X2) Quick Reference Guide THIS AREA FOR SERVICE PROVIDER CONTACT INFORMATION: TDN 07100-00098 Oct 31 2008
MANAGEMENT FUNCTIONS - Access Instructions 1. At ATM Welcome Screen, press and hold down the key (Lower-right corner of keypad), press <1> key, then release both keys. The Password Access prompt is displayed. 2. Enter password and select . The Management Functions MAIN MENU is displayed. RESTART / SHUTDOWN TERMINAL Follow Access Instructions to enter Management Functions. Select SYSTEM PARAMETERS. RESTART TERMINAL: This function reboots the terminal.
DIAGNOSTICS Follow Access instructions to enter Management Functions. Select DIAGNOSTICS > DISPENSER. PURGE: This instructs the dispenser to remove any notes (jams) in feed path. TEST DISPENSE: This instructs the dispenser to dispense minimum one note from each installed cassette into the reject cassette/area. Select DIAGNOSTICS > PRINTER. RESET / TEST PRINTER: This instructs the printer to re initialize and perform a test printout.
CASSETTE CLOSE FUNCTIONS (From the Front Display) Follow Access instructions Select CASSETTE CLOSE. Select cassette(s) to to enter Management Functions. Select TERMINAL CLOSE Functions. Close. A check identifies which cassette(s) are selected. ter>. mark ( √ ) Press . Place selected cassette(s) IN SERVICE. Press . Note: For TDM-200/250 dispensers.
CASSETTE CLOSE FUNCTIONS (From the Rear Operator Service Panel (Touchscreen) Press to Start. Close Cassette(s) - Touch cas- sette options on touchpad until “Asterick” appears. Select “Continue”. Select the cassettes to close. WARNING: Cassette totals will be reset for the selected cassettes * Cassette A: $10.00 Continue Select the cassettes to place in service. * Cassette A: $10.00 * Cassette B: $20.00 * Cassette B: $20.00 Enter Password. Place cassettes “In-Service”.
REPLENISH CASSETTE(S) Note: The RT2000 utilizes TDM dispensers. Currency replenishment for a cassette is the same whether its a single or dual-cassette dispenser mechanism. STEP 1 ACTION Unlock / open vault cabinet door. The dispenser is mounted to a sliding tray. tray ACTION STEP 4 Note: The DOES NOT Place cassette(s) on a flat surface. U nlock note cas - sette with supplied need to be extended key. for currency re - Move plenishment. Open lid.
REPLENISH RECEIPT PAPER Note: This procedure requires terminal is powered up. STEP 1 ACTION Open the rear cabinet sleeve door. If paper remains on roll, cut or tear pa p e r STEP ACTION 4 R elease (O pen ) the blue tension lever shown. Remove any paper from the printer/ cutter assembly. Move between the ten- sion lever back roll and printer. to the CLOSED position . Ro- tate the Down printer assem bly. 2 Remove 5 spent pa- per roll and spind l e f r o m pa p e r bracket.
COMBINATION LOCKS Introduction The security cabinet can be secured using either a mechanical or electronic combination lock. This page covers how to operate the combination of either lock. Operating the Mechanical Lock Unlocking the Lock There are two marks on the dial ring. The index at the top is used for opening the lock, The index 30 degrees to the left is used only when changing the combination. The dial should always be turned slowly and evenly.
