WIRELESS HEADPHNE User Manual Model No:B050 Bluetooth V5.
Welcome to use Thank you for purchasing Bluetooth Active Noise Cancelling B050, Please read the user manual carefully before using . Safety Warning 1. Please read the user manual carefully before using and follow the instructions. 2. Please do not modify, assemble, disassemble this headphone. Otherwise, it may cause this Bluetooth headset with noise, fire, leakage of electricity, crash and other issues. Such problems caused by human error are not covered by the warranty range. 3.
Packaging list 1. Bluetooth Headphone*1 2. Micro USB Cable*1 3. 3.5mm Audio Cable*1 4. User manual *1 Charging Red LED light is always on during charging, The red light is off when fully charged, It usually takes about 2~2.5 hours. 1、Use micro USB charging cable plugs into the USB interface connector. 2、Then the other port of the USB charging cable plug into the interface connector on other device or computer. Low Battery Alarm: When the battery power is less than 10% and the voltage is lower than 3.
Pairing with computer or other devices 1. You should use Bluetooth adapter if your computer does not support Bluetooth. 2. Plug the Bluetooth adapter into the computer's USB port and make sure the Bluetooth function of the adapter is activated. 3. Long press the "Power" button for about 5 seconds to enter pairing mode. 4. Open the Bluetooth software which installed in your PC and select "Search for Bluetooth Devices." Please refer to the details of the Bluetooth software manual. 5.
about 5 seconds when the will flash in an alternating headphone power off . pattern, “connected”voice prompt, after pairing successful Phone Call Control Status Operating Answer incoming call Short press " End a call Prompt " to answer a call There will be a voice prompt while there is a call incoming or ring when the call coming Short press " The end of the call "beep" " while the call in progress tone, blue LED light will be always on.
Volume + Short press the "+" button to Blue light is on,, There is a increase the volume “beep”prompt tone while the volume is to Maximum Volume - Short press the "-" button to Blue light is on, There is a decrease the volume “beep”prompt tone when the volume is to Minimum.
In a call Blue light is on End a call Blue light is on Clean paired device list The red and blue LED flash alternately Charging Red LED is on when charging; red LED is off when full charged. Low Voltage Red LED flashes per 2s Trouble removal Can not power on Please check if low capacity of battery and charging. No sound when connected to a external device via Bluetooth .
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
