Datasheet

Css(nF) Vref(V)

Tss(ms) =

Iss( A)

TPS54620

SLVS949C – MAY 2009– REVISED MAY 2011

www.ti.com

Slow Start (SS/TR)

The device uses the lower voltage of the internal voltage reference or the SS/TR pin voltage as the reference

voltage and regulates the output accordingly. A capacitor on the SS/TR pin to ground implements a slow start

time. The device has an internal pull-up current source of 2.3μA that charges the external slow start capacitor.

The calculations for the slow start time (Tss, 10% to 90%) and slow start capacitor (Css) are shown in

Equation 5. The voltage reference (Vref) is 0.8 V and the slow start charge current (Iss) is 2.3μA.

(5)

When the input UVLO is triggered, the EN pin is pulled below 1.21V, or a thermal shutdown event occurs the

device stops switching and enters low current operation. At the subsequent power up, when the shutdown

condition is removed, the device does not start switching until it has discharged its SS/TR pin to ground ensuring

proper soft start behavior.

Power Good (PWRGD)

The PWRGD pin is an open drain output. Once the VSENSE pin is between 94% and 106% of the internal

voltage reference the PWRGD pin pull-down is de-asserted and the pin floats. It is recommended to use a

pull-up resistor between the values of 10kΩ and 100kΩ to a voltage source that is 5.5V or less. The PWRGD is

in a defined state once the VIN input voltage is greater than 1V but with reduced current sinking capability. The

PWRGD achieves full current sinking capability once the VIN input voltage is above 4.5V.

The PWRGD pin is pulled low when VSENSE is lower than 91% or greater than 109% of the nominal internal

reference voltage. Also, the PWRGD is pulled low, if the input UVLO or thermal shutdown are asserted, the EN

pin is pulled low or the SS/TR pin is below 1.4V.

Bootstrap Voltage (BOOT) and Low Dropout Operation

The device has an integrated boot regulator, and requires a small ceramic capacitor between the BOOT and PH

pins to provide the gate drive voltage for the high-side MOSFET. The boot capacitor is charged when the BOOT

pin voltage is less than VIN and BOOT-PH voltage is below regulation. The value of this ceramic capacitor

should be 0.1μF. A ceramic capacitor with an X7R or X5R grade dielectric with a voltage rating of 10V or higher

is recommended because of the stable characteristics over temperature and voltage.

To improve drop out, the device is designed to operate at 100% duty cycle as long as the BOOT to PH pin

voltage is greater than the BOOT-PH UVLO threshold which is typically 2.1V. When the voltage between BOOT

and PH drops below the BOOT-PH UVLO threshold the high-side MOSFET is turned off and the low-side

MOSFET is turned on allowing the boot capacitor to be recharged. In applications with split input voltage rails

100% duty cycle operation can be achieved as long as (VIN – PVIN) > 4V.

Sequencing (SS/TR)

Many of the common power supply sequencing methods can be implemented using the SS/TR, EN and PWRGD

pins.

The sequential method is illustrated in Figure 22 using two TPS54620 devices. The power good of the first

device is coupled to the EN pin of the second device which enables the second power supply once the primary

supply reaches regulation. Figure 23 shows the results of Figure 22.