Instructions / Assembly

Open the box and put the
two door panels flat on the
ground. Install the hinges
on one side of each of the
two door panels , and note
that the hinges are
installed as close to the
ends of the door panels as
possible to ensure that the
Dutch doors work
properly.Make sure that
the hinges are level.
Place the bottom half of
the door into the door
jamb.Make sure the door is
level and there is a ½" gap
from the bottom of the door
to the floor. When the door
is level, place the hinges
on the door jamb. Use the
holes on the hinges as a
guide for pre-drilling. After
pre-drilling the holes insert
the screws and fasten.
Place the top half of the door
on top of the lower half.Make
sure the door is level.When
the top half is in place, put the
hinges on the door jamb as a
guide for pre-drilling. When
the holes are completed
insert the screws and fasten.
After confirming that
the Dutch doors work properly,
remove the mounting plate.
Contents (2 Door Panel Set)
4
Install the mounting plate
in the recessed position
of the lower door panel.
Requires pre-
drilling and
insertion screws
NOTE:The package does not include the hinge hardware. Need to prepare by yourself.
Upper panel
Mounting plate
Lower panel
Make sure there is a distance of 1/8"
between the upper and lower door panels.
A1 *1
C1 *1
A2 *1
A1
A2
A2
A2
C1