Use And Care Manual

Welcome!
Thank you for purchasing Tech Toyz’ Aerodrone X11, 4 Channel Quadcopter.
Please store this manual in a safe place for future reference.
GETTING STARTED

Remove the product from the box.

Remove any packaging from the product.

Please read all instructions and retain all packaging until you have checked and counted all of the parts.
PACKAGE CONTENTS
 X11 Quadcopter
 Remote Controller
 USB Charging Cable
 Removable Rechargeable battery (pre-installed in the quadcopter)
 4 Landing Gears with Lock Screws and a Mini Screwdriver
 4 Spare Blades
 Instruction Manual
INSTRUCTIONS FOR USE
Battery installation on the Remote Controller
Use a screwdriver to open the battery cover of the remote controller. Install 4 x “AA” batteries (not included)
in the battery compartment as indicated. Put back the battery cover and use the screwdriver to secure.
Notice:
1. Install the battery as per the indicated polarity.
2. Do not mix new and old batteries.
Instructions to charge the Quadcopter
1. Ensure the quadcopter is OFF.
2. Pull out the battery wire from the power port.
3. Insert the USB plug of the USB Charging Cable (included) into the computer USB port and connect the
other end of the cable to the battery connector, indicator lights up.
4. USB indicator lights off when it is charging or completed (about 60 mins).
5. Disconnect the battery connector and reconnect the battery to the quadcopter.
6. Once fully recharged, the quadcopter can fly for about 5-6 minutes. Actual fly time can vary based on
individual handling & flying conditions.
Note: Battery life / Flying time may vary depending on flying conditions, handling, control range etc.
Caution:
 If the quadcopter needs to be recharged, allow 15-30 minutes for it to cool down before recharging.
 Do not overcharge the battery.
 If the battery becomes too hot while charging then remove it from charging immediately and allow it to
cool down.
 Do not reconstruct battery.
 Do not connect the battery to an electrical outlet.