Installation Sheet

1.7

Installation Instructions for

Aero

700FJAE_

920FJAERO

HEADS-LOW VOLTAGE

If applicable accessory fits tight or loose onto the Aero

fixture, then carefully bend the grooved shade holder

tabs in or out slightly with needlenose pliers.

GROOVED

SHADE HOLDER

NEEDLENOSE

PLIERS

GROOVED SHADE

HOLDER TAB

CAUTION: To reduce the risk of a burn or electric

shock during relamping, disconnect the power to

the fixture.

Use MAX 50 Watt, MR16 Front Cover Halogen

Lamp.

NOTE: Bend the grooved shade holder tabs carefully.

Excessive bending may break the tabs.

ACCESSORY SHADE

MR16 LAMP

Insert the MR16 lamp into the proper accessory shade.

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

Round Glass Shield, Cone Glass Shield, Martini, Dichroic,

Moonlet, Firebird Glass Shield, Prism, Belladonna, Bell,

Tinkerbell, Lil Egypt, Meteorite, Moonlet, Droplet, and Wood

Handle are the applicable accessories.

PAGE 1
920FJAERO Installation Instructions for Aero 700FJAE_ 1.7 HEADS-LOW VOLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Round Glass Shield, Cone Glass Shield, Martini, Dichroic, Moonlet, Firebird Glass Shield, Prism, Belladonna, Bell, Tinkerbell, Lil Egypt, Meteorite, Moonlet, Droplet, and Wood Handle are the applicable accessories.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS 1C To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – Use this fixture indoors only. – Do not look directly at the lighted lamp. – Do not remain in light if skin feels warm. – Risk of fire: Use only the type of lamp and maximum wattage indicated in this instruction manual. – Never cover the halogen lamp with anything other than a Tech Lighting lamp shield and never place flammable material close to your fixture.