Manual

28
CS SERIES
Connect the level sensor assembly into the pigtail with the round connector
terminating at the control end of the harness assembly. The connector is a round
locking connector that is keyed so it can only be plugged in one way.
Connector to Main Control Connector for Level Sensor
Figure 13.1 Harness Assembly Figure 13.2
Senor Assembly Connector
Connect the solenoid valve and the lid switch into the appropriate connectors on
the connector box. These are located on the circuit board inside the box and are
labeled. The solenoid connector is a 6 pin locking connector and the lid switch is a
2 pin locking connector. Each is keyed so they can only be plugged in one way.
Cryowire Port Power
Cryowire Port
Battery
Remote Alarm
Valve and Freeze Guard
Sensor Connector
Harness Connector
to Main Control
Lid Switch Connector
Figure 14.0 Harness Assembly & Back Panel