Install Instructions

ManualsBrandsTaco ManualsPlumbing ProductTacoGenie 1/40 HP Non-Submersible Hot Water Recirculating Pump with 1/2 in. Threaded Connection

Pre-Fab Easy Installation For

Model 0011-CF-USK

Installation and Operating Instructions for Existing Homes

Or Buildings with Standard Piping

lant I.D. 001-1184 EFFECTIVE: June 15, 2015

102-153

TacoGenie

is manufactured using the highest quality component parts avail-

able. Patented Integral Flow Checks (IFC) are built into each TacoGenie pump

to prevent cold water from entering the hot water line. State-of-the-art electron-

ics allow the TacoGenie to accurately sense temperature and automatically shut

off the pump to maximize comfort and energy savings. TacoGenie saves energy

and water. You can look forward to over 15 years of life expectancy with a Taco

TacoGenie.

www.TacoComfort.com

A Taco resource – saving product

Instruction Sheet

Summary of content (6 pages)

PAGE 1
02-153 Instruction Sheet Plant I.D. 001-1184 Pre-Fab Easy Installation For Model 0011-CF-USK Installation and Operating Instructions for Existing Homes Or Buildings with Standard Piping EFFECTIVE: June 15, 2015 TacoGenieTM is manufactured using the highest quality component parts available. Patented Integral Flow Checks (IFC) are built into each TacoGenie pump to prevent cold water from entering the hot water line.
PAGE 2
Installation shall be in accordance with the manufacturer’s instructions or warranty may be voided. IMPORTANT Operation of the TacoGenie without being plumbed into water lines may damage the pump and void the warranty. WARNING: In the event the retaining screws have been pulled out of the housing, DO NOT replace them. Use of any other screw may short out the stator windings, creating a risk of electrical shock.
PAGE 3
INSTALLATION FOR THE CF-SERIES TACO GENIE MODEL 0011-CF-USK The two custom adapter “T”s are designed to simplify your installation to 1⁄2" copper hot and cold supply lines. If you have plumbing other than as shown in these instructions, additional fittings may be required. Consult a plumbing professional. ELECTRICAL SUPPLY A 110V electrical supply outlet is required to power the TacoGenie unit. If an outlet is not available, install a 110V outlet in accordance with all local electrical codes.
PAGE 4
3. Attach shut-off flanges to pump. 4. Connect flex lines to tees. 5. Connect flex lines to pump. INSTALLING THE TACO GENIE STARTER BUTTON The manual starter button is a unique feature to the TacoGenie. Using the manual start button maximizes energy savings and controls operation only when there is a request for hot water. 1. Drill a 5⁄8" hole into the desired location, typically the side or front of a vanity cabinet. 2.
PAGE 5
TROUBLESHOOTING – DIAGNOSING SPECIFIC PROBLEMS PROBLEM 1. The pump does not run when push button is pressed. Green LED does not illuminate. 2. The water is not hot enough. 3. There is hot water at the cold water tap. 4. Water is not hot enough when pump shuts down. 5. There is hot water in the cold water lines only POSSIBLE CAUSE A. No power at electrical outlet B.
PAGE 6
LIMITED WARRANTY STATEMENT Taco, Inc. will repair or replace without charge (at the company’s option) any Taco 00 Series circulator or circulator part which is proven defective under normal use within three (3) years from the date of manufacture. In order to obtain service under this warranty, it is the responsibility of the purchaser to promptly notify the local Taco stocking distributor or Taco in writing and promptly deliver the subject product or part, delivery prepaid, to the stocking distributor.