Instructions / Assembly

ManualsBrandsSuncourt ManualsHeating, Ventilation, and Air ConditioningThru Wall Fan Hardwired Variable Speed

208Print

http://www.suncourt.com/TW208Print.html[1/18/2012 11:42:14 AM]

INSTALLATION INSTRUCTIONS FOR THE THRUWALL ROOM TO ROOM

FAN™

READ AND SAVE THESE INSTRUCTIONS IMPORTANT NOTICE

MODEL: TW208P

WARNING - To Reduce The Risk Of Fire Or Electric Shock, Read These Instructions

Before Installing Your Thruwall TW208P Room To Room Fan.

This fan is not to be installed in an outside wall.

Do not use in wet or damp locations.

Do not install in fire rated walls.

Do not use in a window.

Do not connect to a secondary remote speed control.

Not for bathroom use.

With the use of any electrical appliance, it is important to observe all basic precautions to

minimize the risk associated with use, such as electrical shock, fire, or injury to persons. If

you have doubts or are unfamiliar with this type of installation work, seek the services of a

qualified electrician. Suncourt assumes no responsibility for installation of the ThruWall

FanTM. For your safety and protection follow all instructions and adhere to applicable

building and/or electrical codes.

NEVER EXPOSE YOUR THRUWALL TO TEMPERATURES OVER 140°F

(60°C)

WARNING - To Reduce The Risk Of Fire, Electric Shock Or Injury To Persons, Observe

The Following:

Installation work and electrical wiring must be done by qualified person(s) in accordance

with all applicable codes and standards, including fire-rated construction.

When cutting or drilling into wall, do not damage electrical wiring or other hidden utilities.

Prior to installation of the TW208P fan, switch power off at service panel and lock service

panel to prevent power from being switched on accidentally. When the service

disconnecting means cannot be locked, securely fasten a prominent warning device, such

as a tag, to the service panel.

Summary of content (4 pages)

PAGE 1
208Print INSTALLATION INSTRUCTIONS FOR THE THRUWALL ROOM TO ROOM FAN™ READ AND SAVE THESE INSTRUCTIONS IMPORTANT NOTICE MODEL: TW208P WARNING - To Reduce The Risk Of Fire Or Electric Shock, Read These Instructions Before Installing Your Thruwall TW208P Room To Room Fan. This fan is not to be installed in an outside wall. Do not use in wet or damp locations. Do not install in fire rated walls. Do not use in a window. Do not connect to a secondary remote speed control. Not for bathroom use.
PAGE 2
08Print STEP BY STEP INSTALLATION INSTRUCTIONS Step 1. Depending on your needs, the ThruWallTM can be installed high or low on the wall. Please note that warm air rises, thus is found near the ceiling. Conversely, cold air falls and is found near the floor. The temperature of the air near the ceiling may be as much as 10°F to 15°F higher than near the floor. Start by making sure that there are NO studs, water, drain, electrical or other obstructions in the wall where you wish to install the unit.
PAGE 3
208Print Step 11. Check to see that your strain relief is securely fastened and re-attach the electrical box cover. DO NOT OVERTIGHTEN! Step12. Insert the metal sleeve with grille into the cutout opening (fan output side) and screw the grille down snugly. Step13. Insert the other metal sleeve into the cutout opening (fan suction side) and snug the flange up against the wall material. Step14.
PAGE 4
208Print (3) Wire Nuts ONE YEAR LIMITED WARRANTY Subject to the following limitations, Suncourt Inc. (manufacturer) warrants that the ThruWall FanTM will, for 1 (one) year from date of original retail purchase, but not exceeding 2 (two) years from date of manufacture, remain free from appearance of defects in workmanship or materials.