DVI USB KVM Switch 4 Port StarView DVI USB KVM Switch SV431DVIUA Instruction Manual Actual product may vary from photo
FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Instruction Manual Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Package Contents . . . . . . . . . .
Instruction Manual Introduction Thank you for purchasing a StarTech.com 4 Port StarView DVI USB KVM Switch. This product offers a cost-effective way to operate up to four computers or servers from a single keyboard, monitor and mouse peripheral set, while saving valuable deskspace. Featuring USB peripheral sharing, audio switching and astounding video resolutions of up to 1920 x 1440 (@60/70Hz), this is the perfect combination of computer control and multimedia quality.
Instruction Manual Installation PC BIOS Notice: The following BIOS setup changes are necessary for PC users but are not required for Mac users: 1) In STANDARD CMOS, set HALT ON ERROR to ALL BUT KEYBOARD. 2) In PNP AND PCI SETUP, set PNP OS INSTALLED to YES and set the USB IRQ to ENABLED. Console Connection Before installation, please ensure that all devices and computers to be connected to the KVM Switch have been turned off.
Instruction Manual Connecting Slave Computers There are two options for connecting slave computers to SV431DVIUA: 1 a) Using a Male to Male DVI-D (Single Link) cable, connect the computer’s DVI port to one of the four available PC ports (PC 1, PC 2, PC 3, PC 4) as shown below. 1 b) Using a USB A-B Cable, connect the USB port that corresponds with the PC port used in step 1, to the USB port on the corresponding computer, as shown below.
Instruction Manual Operation Please note: SV431DVIUA can be used with a VGA connection to controlled (slave) computers, however an adapter must be used to make the connection (please see Accessory Products from StarTech.com - DVIVGAMF). Also note: Analog and digital connections cannot be used concurrently. To successfully connect SV431DVIUA to the slave computers, all connections must be either digital or analog. SV431DVIUA Front Panel 1 2 1.
Instruction Manual “FUNC” Button To adjust the optimal video signal strength corresponding to the length or quality of DVI cable being used, use the FUNC button in combination with the other front panel pushbuttons. 1. Press the FUNC button three times. The POWER LED will flash once per second. 2. To adjust equalization of the selected port input video strength, press button 1 once or twice; SV431DVIUA will beep once (normal) or twice (enhanced) respectively.
Instruction Manual Rack Mount Kit (Optional) The figure below shows how to attach optional mounting brackets and cable support (SV431RACK) to SV431DVIUA for use with a standard 19” rack cabinet: To Rack Cabinet Back Post To Rack Cabinet Back Post USB or M onitor Cab les to the switch Two screws secure the cable support USB or Monitor cables to a computer 6
Instruction Manual Troubleshooting Symptom Keyboard or mouse does not work Causes Solutions Press any front panel button In Auto Scan mode, the to select a computer, then keyboard and mouse are not use the keyboard and operable. mouse. Improper device driver Newly installed USB device does not work The device should be Device consumes too much self-powered; add a power power. adapter to the device. Improper device initialization Computer hangs while switching computers Re-install device driver.
Instruction Manual Accessory Products from StarTech.com Contact your local StarTech.com dealer or visit www.startech.com for cables or other accessories that will help you get the best performance out of your new product. USBDVI4N1A6 6 ft. 4-in-1 USB, DVI, Audio, and Microphone KVM Switch Cable USBDVI4N1A10 10 ft. 4-in-1 USB, DVI, Audio, and Microphone KVM Switch Cable USBDVI4N1A15 15 ft. 4-in-1 USB, DVI, Audio, and Microphone KVM Switch Cable DVIVGAMF DVI to VGA Display Adapter M/F Specifications No.
Instruction Manual Technical Support StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads. Warranty Information This product is backed by a three year warranty. In addition, StarTech.
About StarTech.com StarTech.com is “The Professionals’ Source for Hard-to-Find Computer Parts”. Since 1985, we have been providing IT professionals with the quality products they need to complete their solutions. We offer an unmatched selection of computer parts, cables, server management solutions and A/V products and serve a worldwide market through our locations in the United States, Canada, the United Kingdom and Taiwan. Visit www.startech.
