User Manual
Instruction Manual
3
3. By default, the DRW150SAT/DRW150SATBK is congured for use LED on it’s front
panel. If you wish to use a dierent LED indicator, move the switch on the rear panel
to the rightmost position (as illustrated below).
4. Insert the bay into the 5.25” bay slot, making sure that the screw holes on the side or
bottom of the bay line up with the holes in the bay slot.
5. Connect your computer’s SATA port to the connector on the back of the bay with
the included SATA cable.
6. Plug either an LP4 molex or SATA power connector from your computer’s power
supply into the power port on the back of the unit.
7. Using the supplied screws, securely mount the bay into the PC.
LP4 molex
LED on/o
switch
7-pin
SATA
15-pin
SATA
power