Operating Guide

9123-1204
1
12
Your Electronic Safe Combination:
Serial #:
®
Installation Instructions
ENTERING YOUR SECURITY CODE
To enter your own security code you will need to follow
the steps listed below:
1. Aer installing the baeries, locate the small red
buon on the inside of the door near the hinge.
2. Press the red buon and then release it, you will hear
a beep. DO NOT SHUT THE DOOR UNTIL YOU
HAVE CONFIRMED THAT YOUR NEW SECURITY
CODE HAS BEEN ENTERED CORRECTLY.
3. With the door open, enter your own personal security
code, which can be 3-8 digits long, and conrm your new
code by pressing the "
# " key on the electronic touch
pad. Before you close the door, try the new security
code to make sure the lock releases the knob so you can
turn it and retract the live action locking bolts.
If the code fails, go through steps 1-3 again. If the code
works successfully, then you should lock the safe.
When you open the safe in the future enter the security
code you have set followed by the " " key and turn the
knob.
If the incorrect security code is entered 3 times you will
have an automatic lockout for 20 seconds before you can
try your code again.
If the incorrect security code is entered 3 additional
times there will be a 5-minute lockout before the code
can be tried again.
IMPORTANT
Record the serial number from the tag on the back of
the safe or the tag on the inside of the lock cover plate
on the front of the safe. Record your combination
number.
Keep keys in a secure place away from children.
For electronic safes - DO NOT STORE KEYS OR
YOUR COMBINATION INSIDE SAFE
Insert key into slot and turn in a clockwise direction.
en pull the door open without removing the key.
If you lose your key please see the instructions at the
end of this instruction sheet.
KEY SAFES
When you rst recieve your new electronic safe you
will need to open the door with the key in order to
install the baeries. Baeries are included and are
located inside the safe in the hardware bag.
To open the door with the key, rst remove the small
central panel from the front of the faceplate. Insert the
key and turn counterclockwise. Turn the knob to the
right and open the door.
NOTE: is key has also been provided in case you
lose or forget your security code or the baeries run
low. If you lose your key, you may purchase a
replacement key by referencing the serial number
located under the removable central panel. See section
at the boom of this instruction regarding replacement
keys.
Locate the baeries inside the safe. Open the baery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install the
baeries.
ELECTRONIC SAFES
NOTE: You can store your Key #, Serial #
and Combination on Stack-On’s SECURE
web site – www.stack-on.com under Service.
Storing your Key # or Combination will provide
instant access to this important information
should you ever lose your keys or your
combination.
Only you will have access to this information.
Tools required: 10mm wrench, drill, 3/8” (9.5mm) drill bit.