OPERATING INSTRUCTIONS PM-9901 DIRECT DRIVE TURN TABLE TURN TA B L E
PRECAUTIONS Thank you for purchasing this fine product – STEREO TURNTABLE. Taking time to read these operation instructions carefully. Read this manual carefully before using the unit and be sure to store the manual in a safe place for future reference. 1. Power sources This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local Power Company.
NAME OF PARTS 1). 2). 3). 4). 5). 6). 7). 45-rpm Adaptor Slip Mat Center Spindle Strobe Dots Power Switch / Strobe Start/Stop Button Beat Out : Frequency output of beat out is 675Hz while pitch is in middle position 0% 8). Taget Light 9). Remote Control : This jack can be connected with an external switch to perform the Start/Stop operation. 10). Headshell 11). Speed Select Buttons 12).
BEFORE USE CONNECTIONS ※ Check following parts included in the package with the main unit: 1. Connect the power cord to the auxiliary power outlet on the rear panel of your amplifier or receiver or to a household AC outlet. 2. Connect the unit output terminals to the PHONO jack of your amplifier or receiver.
A CS OSNETM EN BTLS Y 1. Remove the main unit with the packing from the box and take off the packing. 2. Set the 45-rpm adaptor on the main unit. 3. Insert the turntable platter onto the center spindle. 4. Set the slip mat on the platter. 5. Installation of cartridge: When installing a cartridge, refer to the operating instructions of that cartridge. During installation, attach the stylus protector to guard the stylus tip from damage. (1) Connect the lead wires to the cartridge terminals.
OPERATION STYLUS REPLACEMENT 1. Push the power button to turn on the power, the speed indicator and the strobe-illuminator will light up. 2. Place a record on the slip mat, when playing a 45rpm record with a large center hole, place the 45-rpm adaptor on the center spindle. 3. Set the speed to match the record. 4. Remove the stylus protector, release the arm clamp. 5. Set the cueing lever to the up position. 6. Press the Start/Stop button, the turntable platter will start to rotate. 7.
C GENERAL O N T E N T SSPECIFICATION 1. APPLICATION : This spectftcation applies to the Direct drive turntable unit PM-9901 2. TURNTABLE SECTION: Type Motor Driving Method Turntable plater Speeds Wow and Flutter S/N ratio Pitch Controls Starting Time Time for speed change Beat Output High of cue (first track) 2-speed full manual 8 pole, 2phase, brushless DC motor Direct Drive 330mm dia. Aluminum diecast 33-1/3 and 45 rpm Less than 0.15% WRMS(JIS WTD) More than 55 dB(DIN-B) +/- 10% Less than 1 sec.
C TROUBLE O N T E N T SSHOOTING Sometimes, an operational fault can be mistaken for a malfunction or failure. Check the following points and see if you can find the symptoms of the trouble below before you get in touch with the serviceman. If you cannot locate the symptoms, contact your nearest dealer. Symptom Possible Trouble Remedy Platter does not rotate. Power cord is unplugged. Plug cord securely into wall outlet. No Sound Phono cables are not connected properly.
