User's Manual

Electrical parameters：
1. Operating voltage：DC3.7V 5. Charging voltage/current：DC5V/500mA
2. Working current：30mA 6. Bluetooth transmission distance：〈=8M
3. Continuous use：15H 7. battery capacity：600mAh
4. Dormancy current：<35uA 8. Standby time：30 days at full power
Precautions:
1. Please do not store this product in a humid or hot place;
2. Do not strike, beat, hit, pierce, or attempt to disassemble the product to avoid unnecessary damage to the product;
3. Built-in battery, do not throw it away with garbage;
4. Do not charge the controller near or other heat sources;
5. Non-professionals should not disassemble this product, otherwise it will not be included in the after-sales warranty service.
Frequently asked questions:
Q: the mobile phone Bluetooth open can not search the handle?
A: Cancel the handle and the phone before the Bluetooth pairing device name, re-open the phone Bluetooth search pairing.
Q: Why does the new handle does not turn on?
A: The new handle is generally not enough power, please use the USB cable in the box to connect to the 5V charger, to charge the
handle. Fully charged and then press the power on button to turn on.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this device does
cause harmful interference to radio or television reception, which can be determined by turning the device off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the device and receiver.
--Connect the device into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation,
Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences. (2) Cet appareil doit accepter toutes les interférences, y
compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil