Operator Interface Module (OIM) Kit, M/N 925WK0101 Manual

©1999 Rockwell International Corporation
WebPak and Reliance are trademarks of Rockwell Automation.
WebPak 3000 Operator Interface Module (OIM) Kit
M/N 925WK0101
Instruction Manual D2-3461
Product Description
The WebPak 3000 Operator Interface Module (
OIM
) Kit is used to replace the drive’s built-in keypad and display.
The
OIM
enables you to change drive parameters, operate the drive, and monitor drive operation. The contents
of the kit are listed in table 1.
Preparing to Replace the OIM
Before replacing the
OIM
, disconnect power from the drive.
You will need the following tools:
• #1 Phillips screwdriver
• #2 Phillips screwdriver
• M7 Hex wrench or socket wrench
Accessing the OIM and Disconnecting It from the Regulator Board
Important: Unless otherwise indicated, keep all hardware for the replacement procedure.
Step 1. Loosen the screws that secure the front cover to the drive.
Step 2. Remove the front cover.
!
ATTENTION:Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, or service this equipment.
Read and understand this manual in its entirety before proceeding. Failure to observe this
precaution could result in severe bodily injury or loss of life.
ATTENTION:Do not install or remove the
OIM
with power applied to the drive. Disconnect and
lockout incoming power before attempting installation or removal. Failure to observe this
precaution could result in severe bodily injury or loss of life.
Table 1 – Contents of the WebPak 3000 Operator Interface Module Kit
Description Quantity Part Number
Operator Interface Module 1 807313-2R
Instruction Manual 1 D2-3461