Installation Instructions Manual
Analog Output Module 13
4#,*$"3*/. $3/#&1
The front panel of the module contains a green RUN and a red FLT
(fault) indicator. Possible module fault causes and corrective actions
are shown in the table below.
Indicators Probable Cause Recommended Action
(1&&. /.
1&% /''
6"*3*.( $/.'*(41"3*/. !
/1-", /0&1"3*/.
3 0/6&140 3)& -/%4,& /43043 *2
%*2"#,&% 4.3*, 3)& -/%4,& 1&$&*5&2 3)&
'*123 ! )& /43043 *2 &."#,&% ".%
(/&2 3/ 3)& 5",4& 2&.3 *. 3)& !
./1-", /0&1"3*/.
/.&
(1&&. /.
1&% /.
.24$$&22'4, 0/6&1940
'"4,3
)&$+24- &11/1
"1%6"1& '"*,41& *. -/%4,&
8$,& 0/6&1
&341. -/%4,& '/1 1&0"*1
(1&&. /''
1&% /''
/ 0/6&1
"% *.3&1.", '42&
41. /'' 0/6&1
&-/5& ".% 1&*.2&13 -/%4,& *.3/
$)"22*2 &341. 0/6&1
' 01/#,&- 23*,, &7*232 ".% $)"22*2 0/6&1
2400,8 *2 '4.$3*/.*.( 01/0&1,8 1&341. 3)&
-/%4,& '/1 1&0"*1
Read Block Transfer Status Words
The module allows a five-word read block transfer for rudimentary
program or hardware debugging. If a read block transfer request is
for more or less than five words, the module will not perform a read
block transfer. The following table shows the word assignment for
the read block transfer.
Decimal Bit 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
Octal Bit 17 16 15 14 13 12 11 10 07 06 05 04 03 02 01 00
!/1% )"..&, .043 "3"
)"..&, .043 "3"
)"..&, .043 "3"
)"..&, .043 "3"
/3
42&%
&2&3
&2&15&% "3" ",*%
The first four words of the read block transfer show the actual 12 bits
of data sent to the module’s digital-to-analog converters (DACs).
The first four words in the read block transfer appear in 12-bit binary
format regardless of the module’s mode of operation (BCD or 12-bit
binary).
1&&.
*.%*$"3/1
&%
*.%*$"3/1
Diagnostics and
Troubleshooting