User Manual

All RockBoard® pedalboards include enough hook & loop tape to fully cover the top of the pedalboard and the correlating amount of pedals.
Mounting Eects Pedals with Hook & Loop Tape:
Mounting Eects Pedals with the RockBoard® QuickMount System:
As an alternative to classic hook & loop tape, RockBoard® QuickMount® mounting plates provide a well-engineered, professional solution for mounting
eects pedals to the board. QuickMount® elements fasten tightly to withstand even the heaviest use and can be removed in seconds when it is time
to change your setup. For xing the plates to pedals, no permanent modications are necessary so the original condition can easily be restored any
time. QuickMount® systems are available for most popular pedal sizes, including wahs and specialty pedals. The variety is continually updated to t the
models of most diverse pedal builders.
For a complete summary of all available QuickMount® products, detailed step-by-step mounting instructions, and further information please refer to
www.rockboard.net
Attach and Exchange the Rubber Feet:
The rubber feet on all RockBoard® pedalboards are mounted with M3 screws using a 3 mm hex key drive and counter nuts. Should one of the feet be
damaged or lost, simply replace it by unscrewing the foot. For this purpose, your RockBoard® pedalboard comes with two replacement rubber feet,
a 3 mm hex key wrench, two M3 x 12 mm screws and two counter nuts.
USA DISTRIBUTION: Framus & Warwick Music USA, Inc. | [e-mail] | 629.202.6790
CHINESE DISTRIBUTION: Warwick Music Equipment Trading (Shanghai) Co. Ltd. | [e-mail] | [phone]
NORTH EUROPEAN DISTRIBUTION: www.rockboard.de | [e-mail] | www.w-distribution.de | www.facebook.com/warwickmusicdistribution
Headquarters: Warwick GmbH & Co. Music Equipment KG | 08258 Markneukirchen / Germany | [phone] / 555 - 0
Family Owned • Solar Powered • Sustainably Manufactured in a Green Environment
Step 1
Make sure the surface of your RockBoard® pedalboard
is clean and dry. If you must clean your pedalboard, use a
suitable cleaning alcohol or a dry, clean cloth.
Step 2
Take the 1" (2.5 cm) wide loop tape and cut strips to the
length of your RockBoard® pedalboard.
Step 3
Peel 1" - 2" (2.5 - 5.0 cm) of the white protective backing
o and attach the loop tape to one of the horizontal
bars that are positioned between the slots on the board
surface. When the loop tape is positioned correctly,
peel o the rest of the protective foil and stick it to the
board surface. Repeat this step for each of the remaining
horizontal bars.
Step 4
Take the 2" (5.0 cm) wide hook tape and cut it to the
respective size that is required for each of your eects
pedals.
Step 5
Peel o the white protective backing and stick the hook
tape to the back of your eects pedals.
Note: We recommend not to cover serial numbers and
other stickers on the back of your pedals, removing the
hook tape later may damage these.
Step 6
When all your pedals are equipped with hook tape, you
can attach them in the desired layout to your pedalboard
and connect them to power and patch cables.
Step 7
You can bundle up excess cable lengths with the included
cable ties underneath the board surface and attach
them to the underside of the board surface through
the slot grid.
How to set up your new
ROCKBOARD
®
Pedalboard
English