Instructions

Table Of Contents
RIGOL Chapter 2 Command System
2-44 RSA5000 Programming Guide
:CONFigure:MCHPower
Syntax
:CONFigure:MCHPower
Description
Sets the analyzer to be in the MCHP measurement state.
Remarks
This command is only available for GPSA mode.
Running this command will discontinue the current measurement and restore the specified measurement of
the instrument to the default factory state.
After changing any measurement setup, running the
:READ Commands will initialize the measurement, and
you do not have to set the measurement to the default.
:CONFigure:NORMal
Syntax
:CONFigure:NORMal
Description
Sets the analyzer to be in the Normal measurement state.
Remarks
This command is only available for RTSA mode.
Running this command will discontinue the current measurement and restore the specified measurement of
the instrument to the default factory state.
:CONFigure:OBWidth
Syntax
:CONFigure:OBWidth
Description
Sets the analyzer to be in the OBW measurement state.
Remarks
This command is only available for GPSA mode.
Running this command will discontinue the current measurement and restore the specified measurement of
the instrument to the default factory state.
After changing any measurement setup, running the
:READ Commands will initialize the measurement, and
you do not have to set the measurement to the default.