Operator's Manual

ASSEMBLY

Stand Set-Up, continued

5. Tighten the locking nut (Fig 8). Make sure all connec-

tions are rm and the stand is steady.

6. The stand anchors located on the two shorter legs (Fig.

9) may be used to attach the stand to the oor with

screws (not supplied).

Closing the Stand

From the side of the stand with two wheels, rst pull out the

orange knob at the end of the crossbar, as shown in Fig. 10,

then reverse the steps described in “To Open the Stand,”

page 13.

Locking Nut

Fig. 8

Stand Anchors

Fig. 9

Fig. 10