Product Manual B

RDS Manufacturing Inc. Contact:
300 Industrial Park Dr. [e-mail]
Perry, FL 32348 1-850-584-6898
Page 1 of 2
Transfer Fuel Tank Installation Instructions
RDS Manufacturing Fuel Tanks are designed to fit in the BED of a truck. Under no circumstance should an RDS Fuel
Tank be mounted directly to the FRAME of a vehicle. Failure to adhere to this can cause product failure and will VOID
any warranty.
1) With transfer tanks the transfer pump can be installed before mounting the tank to the bed of the truck. Pump
installation depends on the type of pump you purchased so follow the manufactures instructions for installing the
pump.
2) Place tank in bed of truck at desired location. Check underneath the bed to insure the desired tab location does
not interfere with any components of the truck such as wiring or hoses. If the tank has a toolbox make sure the lid
has room to open.
3) Mark the tab locations and also mark the front edge of the tank (closest to tailgate). This will be your starting
point for the neoprene. Also mark the four spots you will place the neoprene strips, space them as evenly as possible.
4) Drill one 5/16” hole in each tab and the bed of the truck (making sure as to not hit any wiring or other critical
components of the truck) for mounting. Drill only one hole per tab. Place a bolt in your first hole to help keep the
tank in-place while drilling the other holes.