Installation Guide

15
16
Electrical grounding is required for this washer.
This appliance must be grounded. In the event of malfunction or breakdown,
grounding will reduce the risk of electric shock by providing a path of least
resistance for electric current.
This appliance is equipped with a power cord having a three-prong grounding
plug for use in a properly installed and grounded outlet.
The plug must be plugged into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and ordinances.
Never connect the ground wire to plastic plumbing lines, gas lines, or hot
water pipes.
Grounding
Installation Instructions
Choose the Proper Location
Electric
Use 120Volt 60Hz 15 Amps fuse or circuit breaker.
Individual branch circuit serving only for your washer is recommended.
Never use an extension cord.
Water
To correctly fill your washer in the proper amount of time, water pressure of
is required.
Water pressure less than 14psi may cause water valve failure, or may not allow
the water valve to shot off completely, or may extend the fill time beyond what
your washer controls allow, causing your washer to turn off and alarm error.
A time limit is built into the controls to prevent flooding in your home if a hose
becomes loose.
The water faucet must be within of the back of your washer to
match the inlet hoses provided with your washer.
To avoid the possibility of water damage:
- Have water faucets easily accessible
- Turn off faucets when the washer is not in use.
- Periodically check that there is no leakage from the water inlet hose fittings.
14
to 70psi (100 to 500 kPa)
4 feet / 122cm
Installation Instructions
Choose the Proper Location
Drain facility
The recommended height of the standpipe is m.
The drain hose must be routed through the drain hose clip to the standpipe.
The standpipe must be large enough to accept the outside diameter of the drain hose.
35in. or 90c
Install Your Washer
Before installing, make sure there are rubber gaskets
inside the fittings at both ends of the water supply
hoses.
If there are no water inlet hoses packed with the washer
or if the hoses are damaged, Call Midea Service
Center at Installing the water supply
hoses without rubber gaskets can cause water leakage.
When you initially install the washer, be sure to use
new hoses. Failing to do so may result in a water
leakage or overflow and may damage your property.
If a hose is too short, replace the hose with a longer,
high pressure hose.
1-866-646-4332.
Coupling
Rubber
gasket
Step 1: Move your washer to selected position
Tilt the unit back onto its rear rollers and push it forward as shown in the figure
below. Move the unit to a location as described in the previous Choose the Proper
Location section.
Make sure the location has a hard, level surface without carpeting.
There should be no direct sunlight.
Do not expose the unit to freezing temperatures (under 32° F or 0° C).
Front of the
washer
Back of the
washer
O
60~70
WARNING
WARNING
WARNING
WARNING
WARNING
Warning-Improper connection of the equipment-grounding conductor
can result in a risk of electric shock, Check with a qualified electrician or
serviceman if you are in doubt as to whether the appliance is properly
grounded.
Do not modify the plug provided with the appliance -if it will not fit the
outlet ,have a proper outlet installed by a qualified electrician