Technical information

ManualsBrandsRadyne ManualsComputer equipmentMM200

User Interfaces MM200 High-Speed Microwave Modem

4-18 TM086 - Rev. 4.1

The primary Tx Interface Screens and their sub-menus as listed below:

Screen Name Selections and Descriptions L0 L1 L2

TX INTRFC1 (menu):

CONTROL

DATA RATE (BPS)

INTERFACE

FRAMING

JIT CONTROL

NULL PID

PID

CLK POLARITY

DATA INVERT

BB LOOP

Transmit Interface 1

{Disable, Enable}

Enables or disables the installed interface.

Dependant upon interface type. For

variable interfaces, this unit must be set

by the user. Will not show up on fixed

rate interfaces.

Dependant upon interface type. Selects

the interface standard for multiple

standard interface card, or displays

standard for fixed interfaces.

{Unframed, MPEG188, MPEG204}

Used for DVB Interface framing selection.

Shows only in DVB Framed Interfaces.

Note: Only appears when supported

by the installed interface.

{NORMAL, STAMP2, STAMP3}

Normal or Time-Stamped packets.

{2-Byte Packet ID}

Defines the 2-byte packet ID, program ID

for null padding packets. This number

must match the corresponding receive

demux null PID. This number must be

unique and not be duplicated by an

interface PID or any DVB transport stream

PIDs on a framed interface.

Note: Only appears when using DVB

Framed Interfaces such as L0I.

Interface Packet ID. This number must

match the corresponding interface at the

Rx site. This number must be unique and

not duplicated on other Tx interfaces.

{Normal, Inverted}

Sets the polarity of the clock.

Note: Only appears when supported

by the installed interface.

{Normal, Inverted}

Sets the polarity of the data.

{Normal, Inverted}

Baseband Loopback. Not yet

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW

RW