User manual

214
To allow a remote PC to connect to VioStor and the IP cameras, you need to:
Step 1. Set up the port mapping (virtual server) on the router.
From Forward to
219.87.144.205:8000 192.168.1.1:80
219.87.144.205:8001 192.168.1.101:80
219.87.144.205:8002 192.168.1.102:80
219.87.144.205:8003 192.168.1.103:80
Step 2. Add the IP camera to VioStor by entering the IP address of the IP camera in
the ‘IP Address’ settings. Enter the public IP address of the router and the mapped
ports of the IP camera in the ‘WAN IP Address’ settings.
Note: When configuring the IP camera, the WAN IP and LAN IP must be entered.
To open FTP (port 21) and SMB (port 445) of VioStor on WAN, configure the
following port mapping settings:
From Forward to
219.87.144.205:21 192.168.1.1:21
219.87.144.205:139 192.168.1.1:139
219.87.144.205:445 192.168.1.1:445
After finishing the above two steps, you can access VioStor over WAN by entering
the IP address http://219.87.144.205:8000 in the IE browser. Then login VioStor
with the correct user name and password.
If the port specified to VioStor is 80, you can enter http://219.87.144.205 to access
VioStor as the default port of HTTP is 80.
Note: If the router does not use a fixed IP, you will need to configure the DDNS
settings on the router. Other configurations are the same as above.