Installation Guide

Pegatha Aluminum Baluster
Installaon Instrucons 2015 V1.0
Step #1 – Measure and Cut Railings
 Measure the distance between your posts and
note the length.
 Use your measurement and mark your top and
bottom rails.
 Use a miter saw to cut your rails to the deter-
mined length.
Check all local building codes before you begin!
www.pegatha.net
Step #2 – Determine Baluster Locations
 Lay your top and bottom rail next to each other
and mark the center of your rails.
 Mark the baluster locations 4 7/8” on center
along both railings. This will allow for 3 3/4” spac-
ing between the balusters.
 Apply stain, paint or other finish to the railings
and posts.
Step #3 – Install Railings
 Install both the top & bottom rails between your
posts.
 Make sure to place a support block under the
bottom rail .
Step #3 – Install Balusters
 We recommend making a wood fixture for in-
stalling Pegatha Face Mount balusters that gives
you the correct spacing between them.
 Place a support block under the bottom railing if
you have not done so in Step 3.
 Find your previously marked lines and use the
provided screws to apply the balusters to the
railings.