Installation Guide

1
L
IMPORTANT
Please read these instructions
carefully before you start to assemble this product.
Please carry out the steps in
the order set out in these instructions.
Keep these instructions in a
safe place for future reference.
» Care & Safety Advice
Please follow the instructions
as listed in this manual.
Sort the parts and check
against the contents list.
For safety purposes we
strongly recommend the product to be assembled by
at least two people.
Some parts have metal
edges. Please be careful when handling components.
Always wear gloves, shoes
and safety goggles during assembly.
Do not attempt to assemble
the Gazebo in windy or wet conditions.
Dispose of all plastic bags
safely - keep them away from children's reach.
Keep children away from the
assembly area.
Do not attempt to assemble
the Gazebo if you are tired, have taken drugs,
medications or alcohol, or if
you are prone to dizzy spells.
When using a stepladder or
power tools, make sure that you are following the
manufacturer's safety advice.
Do not climb or stand on the
roof.
Heavy articles should not be
leaned against the poles.
Keep roof and gutters clean
of snow, dirt & leaves.
Heavy snow load on roof can
damage the Gazebo, making it unsafe to stand
below or nearby.
This product was designed to
be used mainly as a Gazebo.
If the profiles' color was
scratched during assembly, it can be fixed.
Light Transmission - 15%
» Cleaning Instructions
In order to clean the Gazebo,
use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive
cleaners, or other special detergents to clean
the panels.
»Tools & Equipment
TO01(Supplied)
6,
Attention
Please make sure you install the panels with the UV
protected side out
(marked with "THIS SIDE OUT") and peel the film strip
covering the panels.
Screws and plugs are not supplied.
Please tighten all screws when completing assembly.
Anchoring this product to the ground is essential to
its stability and rigidity.
It is required to complete this stage in order for your
warranty to be valid.
During Assembly
During assembly use a soft surface below the parts to
avoid scratches and damages.
When encountering the information icon,
please refer to the
relevant assembly step for additional
comments and assistance.
Step 8b: Carefully spread silicone along the
cross-section of the profile and
immediately attach the profiles together. It is
recommended to wipe the extra
residue silicone.
Step 10: It is recommended to use a carton or other
soft material under the lowered
corner in order to avoid scratches and peeling of paint.
*This note also refers to step 18
Steps 13+14: Optional - if you wish to add curtains /
mosquito netting -
Please thread the plastic clips through the rail in each
profile.
(Curtains / mosquito netting are not supplied).
Add clips according to the specific quantity of curtain
rings.
It is not possible to add the clips at a later time, once
the product is fully assembled.
Steps 19+21: Please note that screws insertion should
be done from the outside.
Afterwards please use the tool TO01.
Steps 18+20: Please note that screws insertion should
be done from the bottom up.
Step 23b: Please add silicone on the inner area of part
#8327 as illustrated.
Step 29a: Please drill holes in the panels to be located
precisely parallel to the holes
in the gutters' profiles.
Step 30: Please level the profile's legs and adapt
screws and plugs to your specific
ground type.