Owner manual

ULTRA EDGE SEQUENTIAL 6/05/2002
22
D e l e t e T o o l # 1
P r e s s 1 t o c o n f i r m
A n o t h e r k e y t o a b o r t
Press “1” key.
T o o l # 1 D e l e t e d
4.9 HOW TO ACTIVATE A TOOL
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position and FEED STATUS screen is displayed. If the current screen is not FEED STATUS one then press
the “OPER” key to bring it up.
Press “TOOLS” key, position the pointer next to Activate tool command and press the “ENTER” key.
E d i t T o o l
A c t i v a t e T o o l <
C r e a t e N e w
P r e s s T O O L S t o e x i t
A c t i v a t e T o o l #
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t
Enter the desired tool number or select it from the tool list using “↑” and “↓” keys and press the “ENTER” key again.
A c t i v a t e # 1 2 3 4 5 6 7
A r r o w k e y s t o s c r o l l
P r e s s T O O L S t o e x i t
T o o l A c t i v a t e d
4.10 HOW TO EDIT “SETUP” PARAMETERS
NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”
position and FEED STATUS screen is displayed. If the current screen is not FEED STATUS one then press
the “OPER” key to bring it up.