Programming Manual

Algovita Spinal Cord Stimulation System
Clinician Programming Manual
17
4. Getting Started
Before using the Clinician Programmer, make sure that Bluetooth is on. Refer to the Apple iPad User Guide at
support.apple.com for instructions.
Aer you log in to the Clinician Programmer, pair the Bridge Communicator with the Clinician Programmer to enable
communication between the Clinician Programmer and a stimulator.
Logging In to the Clinician Programmer
e rst time you launch the Clinician Programmer, verify that you have an internet connection in order to use the login
credentials provided by Nuvectra. You can optionally set up a Touch ID® within iPad Settings and use your nger for future
log-ins. It is also recommended to turn o all Apple iPad system-level notications and alerts in the iPad settings feature.
Responding to any system-level alert or notication while using the Clinician Programmer Application results in the user
being automatically logged out of the Clinician Programmer Application.
To launch the Clinician Programmer Application:
1. Tap on your iPad.
2. Log in with your Nuvectra username and password, or a Touch ID.
If you are unable to authenticate the Clinician Programmer Application for rst time use, the Clinician Programmer
should retry upon a predened timeout when a token is not received.
If you are unable to log in, call Nuvectra Customer Service toll-free at 1-844-727-7897 within the United States or
1-214-618-4980.
Pairing a Bridge Communicator to the Clinician Programmer
To pair the Bridge Communicator with the Clinician Programmer:
1. Place the Bridge Communicator in Bluetooth mode.
a. Tap and hold one of the buttons shown in image a. Do not use the red QSO button.
b. While holding the button from step a, slide the Power On/O button down and hold for two seconds or until bl
displays (bl displays on the Bridge Communicator when it is communicating via Bluetooth).
c. Release all buttons aer bl displays.
b.a.
d. Verify that a P displays and is blinking (Bridge Communicator is ready to pair).
Note: Ready to pair status will time out aer two minutes.
0300-000176-001 Rev.2 SCS CP_Mobile.indb 17 7/12/19 9:20 AM