User Manual

Page | 253
ALT + IN
A different operation results when you hold down ALT (see Section Section 24.7) at the same time as you
push IN. This operation updates the In Point of the active clip in the currently delegated DDR to the frame
currently displayed.
TW-42 NOTES This feature is supported on TW-42 as well.
Hint: This represents a non-destructive edit of the playlist clip, equivalent to dragging the trim handle at the
left-hand end of the DDR scrub bar.
24.6.2 (MARK) OUT
Pushing the OUT button likewise performs a short series of several actions:
 An Out point is assigned to the primary clip
 If the Add to switch is enabled in the Record Configuration panel, the clips is added to any targets
configured in the associated destination menu (new clips are added to the end of the playlist)
Note: This is a non-destructive operation. Rather than actually chopping the file, recording continues without
interruption, and an instance of the file is added to target playlists.
ALT + OUT
A different operation results when you hold down ALT (see Section Section 24.7) at the same time as you
push OUT. This operation updates the Out Point of the active clip in the currently delegated DDR to the frame
currently displayed.
Hint: This is a non-destructive edit of the playlist clip, equivalent to dragging the trim handle at right-hand end
of the DDR scrub bar.
24.6.3 ONE BUTTON MARKING
Another handy method of creating clips for instant replay is referred to as ‘one button marking’. With Record
enabled, watch for notable events, and simply press OUT whenever one occurs (no need to press IN
beforehand in this case). This creates a new clip with an Out Point at the current frame, automatically setting
the In Point to achieve the Duration set in the Record Configuration > Replay tab.
SECTION 24.7 ALT AND QUALIFIERS
FIGURE 24-6