Installation Instruction
Table Of Contents
- Ceiling-mounted ventilation system
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Accessories
- 7 Before using for the first time
- 8 Basic operation
- 8.1 Switching on the appliance
- 8.2 Switching off the appliance
- 8.3 Selecting a fan setting
- 8.4 Switching on intensive mode
- 8.5 Switching off intensive mode
- 8.6 Switching on the fan run-on
- 8.7 Switching off the fan run-on
- 8.8 Switch on automatic mode
- 8.9 Switch off automatic mode
- 8.10 Intermittent ventilation
- 8.11 Sensor control
- 8.12 Setting the sensor control
- 8.13 Setting the saturation indicator
- 8.14 Resetting the saturation indicator
- 8.15 Switching on the lighting
- 8.16 Setting the brightness
- 8.17 Switching on the button tone
- 8.18 Switching the button tone off
- 9 Home Connect
- 10 Hob-based hood control
- 11 Cleaning and servicing
- 12 Troubleshooting
- 13 Customer Service
- 14 Accessories
- 15 Disposal
- 16 Declaration of Conformity
- 17 Installation instructions
Installation instructions en
23
Removing the appliance
WARNING‒Risk of injury!
The appliance is heavy.
▶ To move the appliance, twopeople are required.
▶ Use only suitable tools and equipment.
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
Risk of injury when opening and closing the hinges.
▶ Keep your hands away from the hinges.
1.
Disconnect the appliance from the power supply.
2.
Swing down the filter cover.
Open the filter cover fully and without pulling on it.
3.
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
4.
Press together the cable duct at the sides and re-
move it.
5.
Disconnect the cable at the appropriate point.
6.
Undo the screws on the hinges up to approx.7mm.
5
Do not loosen them fully.
7.
Unhook and remove the filter cover.
8.
Undo the opposite screws to loosen the fan box.
T 20
9.
Push the fan box to the side and release the pipe-
work.
10.
Push the fan box to the other side and pull out the
mains plug.
11.
Screw the fan box firmly back in place.
12.
Loosen the mounting brackets. Push the removal
slide inwards.
13.
Slowly take the appliance out of the cutout.