Specifications

Chapter 1 – AT Commands, S-Registers and Result Codes

Multi-Tech Systems, Inc. SocketModem MT5600SMI/MT5656SMI Reference Guide (S000306B) 4

Chapter 1 – AT Commands, S-

Registers and Result Codes

Introduction

The AT commands are used to control the operation of your modem. They are called AT commands

because the characters AT must precede each command to get the ATtention of the modem.

AT commands can be issued only when the modem is in command mode or online command mode. The

modem is in command mode whenever it is not connected to another modem. The modem is in data

mode whenever it is connected to another modem and ready to exchange data. Online command mode is

a temporary state in which you can issue commands to the modem while connected to another modem.

To put the modem into online command mode from data mode, you must issue an escape sequence

(+++) followed immediately by the AT characters and the command, e.g., +++ to hang up the modem. To

return to data mode from online command mode, you must issue the command ATO.

To send AT commands to the modem, you must use a communications program, such as the

HyperTerminal applet in Windows 98 and NT 4.0, or some other available terminal program. You can

issue commands to the modem either directly, by typing them in the terminal window of the

communications program, or indirectly, by configuring the operating system or communications program

to send the commands automatically. Fortunately, communications programs make daily operation of

modems effortless by hiding the commands from the user. Most users, therefore, need to use AT

commands only when reconfiguring the modem, e.g., to turn autoanswer on or off.

The format for entering an AT command is ATXn, where X is the command, and n is the specific value for

the command, sometimes called the command parameter. The value is always a number. If the value is

zero, you can omit it from the command; thus, AT&W is equivalent to AT&W0. Most commands have a

default value, which is the value that is set at the factory. The default values are shown in the “AT

Command Summary” (See below).

You must press ENTER (depending on the terminal program it could be some other key) to send the

command to the modem. Any time the modem receives a command, it sends a response known as a

result code. The most common result codes are OK, ERROR, and the CONNECT messages that the

modem sends to the computer when it is connecting to another modem. See “Result Codes” at the end of

this chapter for a table of valid result codes.

You can issue several commands in one line, in what is called a command string. The command string

begins with AT and ends when you press ENTER. Spaces to separate the commands are optional; the

command interpreter ignores them. The most familiar command string is the initialization string, which is

used to configure the modem when it is turned on or reset, or when your communications software calls

another modem.

Escape Code Sequence – +++

When the modem has established a connection and has entered online data mode, it is possible to break

into the data transmission in order to issue further commands to the modem in an online command mode.

This is achieved by the DTE sending to the modem a sequence of three ASCII characters specified by S-

of the three-escape character sequence from the DTE and sending of the OK result code to the DTE is

controlled by the S12 register.