Specifications

HHXD5 RIDE-ON TROWEL • OPERATION MANUAL — REV. #2 (05/04/12) — PAGE 19
CONTROLS AND INDICATORS
Figure 4. HHXD5 Controls and Indicators (Clamshell Open)

















31. Radiator/Filler Cap — Holds coolant or water
necessary to keep engine at a safe operating
temperature. Remove this cap to add water or
antifreeze.
32. Blade Speed Pedal — Slow blade speed is
accomplished by slightly depressing the foot pedal
while maximum blade speed is accomplished by fully
depressing the pedal.
33. Overflow Bottle — Supplies coolant to the radiator
when radiator coolant level is low. Fill to indicated level
as shown on bottle.
34. Engine Oil Filler Cap — Remove this cap to add
engine oil.
35. Clamshell Securing Bolt Location (4 places) —
Remove to open clamshell.
36. Clutch and Belt — Drive Pulleys transfer power from
the engine to the gearboxes
37. Spare Belt Carrier — Contains a spare drive belt for
expedient belt replacement.
38. Battery — Provides +12V DC power to the electrical
system
39. Right Side Clamshell — Remove two bolts to open
for service and maintenance access.
40. Left Side Clamshell — Remove two bolts to open for
service and maintenance access.
41. Retardant Spray Filler Cap — Remove this cap to
add spray retardant.
42. Burp Tank — Hydraulic Fluid top-off point.
43. Test Port-Hydraulic Pressure — Hook test guage to
test port to determine hydraulic pressure during operation.
44. Retardant Spray Control Button — Located on both
joysticks. When pressed, allows retardant spray to flow
through the spray nozzle.
The following section is intended as a basic guide to the
ride-on trowel operation, and is not to be considered
a complete guide to concrete finishing. It is strongly
suggested that all operators (experienced and novice) read
“Slabs on Grade ” published by the American Concrete
Institute, Detroit Michigan.