Specifications

PAGE 26 — DCA180SSI/DCA180SSIU 60 HZ GEN. • OPERATION AND PARTS MANUAL — REV. #1 (08/02/10)

GENERATOR OUTPUTS

GENERATOR OUTPUT VOLTAGES

A wide range of voltages are available to supply voltage

for many different applications. Voltages are selected by

applying jumpers (6) to the voltage change-over board

(Figure 13). To obtain some of the voltages as listed in

Table 7 (see below) will require a ﬁne adjustment using

the voltage regulator (VR) control knob located on the

control panel.

Voltage Change-Over Board

The voltage change-over board (Figure 13) is located on

the control box, behind the generator control panel. This

board has been provided for eae of voltage selection.

Figure 13. Voltage Change-Over Board.

Generator Amperage

Table 8 shows the maximum amps the generator can

provide. DO NOT exceed the maximum amps as listed..

CAUTION

NEVER attempt to place jumper plates on the voltage

change-over board while the generator is in operation.

There exist the possibility of electrocution, electrical

shock or burn, which can cause severe bodily harm

or even death!.

Table 7. Voltages Available

Three Phase

(Switchable)

208V 220V 240V 416V 440V 480V

Single Phase

(Switchable)

120V 1127V 139V 240V 254V 277V

Table 8. Generator Maximum Amps

Rated Voltage Maximum Amps

1Ø 120 Volt 400 amps (4 wire)

1Ø 240 Volt 200 amps (4 wire)

3Ø 240 Volt 433 amps

3Ø 480 Volt 216 amps

HOW TO READ THE OUTPUT TERMINAL GAUGE

The AC ammeter and AC voltmeter gauges are controlled

by the AC ammeter and AC voltmeter change-over switches,

Both of these switches are located on the control panel and

DO NOT effect the generator output. They are provided to

help observe the phase to phase voltage and the current

ﬂowing to the load at the UVWO terminals lugs.

Observe that the voltage change-over board (Figure 14)

has been conﬁgured for 3Ø, 240V operation.