User Manual

18 19Quick Start Guide500 SERIES COMPRESSOR LIMITER 522
The 522 module is designed
to be mounted into a 500
series rack chassis or box,
such as the MIDAS Legend
L6 or L10. The L6/L10 supplies the input
and output connections to the 522
module, as well as internal power to run
the module.
With the power to the
L6/L10 turned o , install
the 522 module by
sliding it in carefully so
its rear connector correctly  ts into the
corresponding multi-pin connector of the
L6/L10. Use 2 screws to secure the 522
module to the front top and bottom rails.
Blank spaces in your L6 or
L10 can be  lled using the
MIDAS L1B blank plates.
These plates will prevent
dirt, dust and other objects from entering
the unit.
Insert any other modules in
your system.
Connect your audio
equipment to the input and
output of the L6/L10.
Turn on the power to the
L6/L10. The 522 module is
equipped with an internal
power on/o mute relay.
After power up, there is a 2 second delay
before the output is connected, to avoid
power-on thumps. The relay also prevents
power-o thumps by muting the output
during power down.
Getting Started
Legend L10 500 Series Rackmount Chassis for 10 Modules
Legend L6 500 Series Rackmount Chassis for 6 Modules (supplied rack ear kit not shown)