Installation Instructions

1
INSTALLATION
Parts Included
1. Using a hammer, gently tap
pivot pins and guide into
the pre-drilled holes in the
locations shown.
2. Position overhead track in
the opening with the open
side down and the bracket
end toward the jamb. Center
the track, or allow at least
3/4" between the track and
the front of the opening. If
installing a double set with
two tracks, insert the track
bracket into the two ends
where they meet in the middle
and push the tracks together.
The holes in the bracket
should align with the holes in
the tracks. Center the entire
assembly side to side in the
opening. Secure the track
with the long pan head screws
through the pre-drilled holes until snug. If installing four panels with
two tracks, use a track bracket between the two ends in the center.
3. Position the lower bracket on the oor in line with the overhead track.
The bottom of the bracket must rest securely on the oor or carpet.
Fasten to the jamb and oor with a long at head screw through
eachhole.
4. Place the upper pivot pin
in the hole in the bracket
and the guide in the
track (or in the middle of
the slide guide between
the springs). Lift the door
assembly slightly and
drop the lower pin into
the lower bracket slot.
5. Verify there is a 1/4"
clearance between the
pivot door and the jamb.
Four panel assemblies
should be snug at the middle. If adjustments are necessary, door
panels should be folded, in some cases removed, to gain access to the
adjustment screws.
To adjust horizontally:
6. At the top, loosen the
screw in the top pivot
bracket and move
toward or away from the
jamb until there is 1/4"
clearance. Re-tighten.
7. At the bottom, lift
assembly and move the
adjusting wheel toward
or away from the jamb
until doors are plumb
with jamb, then lower
into bracket.
To adjust vertically:
8. Lift assembly slightly until
the adjustment wheel
clears the slot in the
lower bracket. Rotate
the adjustment wheel
to the left to raise doors
or to the right to lower
them. Be sure the teeth
lock rmly into bracket
whennished.
9. Snap the snugger or
slide guide into the lead
door end of the track as
shown, or in the center
of the track between
guides in a four door
installation. If using a
slide guide, seat lead
door guide pin between
the two springs in the
guide as shown.
OR
OR
OR
Upper Pivot Pin
Guide for Track
Snugger or slide guide Lower pivot pin
Lower Bracket
Track Slide
(optional)
Knob
Aligner
T
rack
Track bracket
(used only for double systems)
OR
OR
Guide
Upper
pivot pin
Jamb
side
Lower
pivot pin
Lower
bracket
Bracket
Pin
Horizontal
adjustment
screw
Adjusting
wheel
1/4"
Slide guide
Snugger
Installation Instructions for Bifold Doors