Operation Manual

26 Installation
Installation
3
NOTE
• This unit supports USB ash memory/external
HDD formatted in FAT16, FAT32 and NTFS when
accessing les (music, photo, movie). The USB
device can be used for local storage for enjoying
BD-Live discs from the Internet.
• Please use the USB ash memory/external HDD
formatted in either FAT16 or FAT32 when using
BD-Live.
• This unit can support up to 4 partitions of the
USB device.
• Do not extract the USB device during operation
(play, recording, etc.).
• A USB device which requires additional
programme installation when you have
connected it to a computer, is not supported.
• USB device: USB device that supports USB1.1
and USB2.0.
• Regular back up is recommended to prevent
data loss.
• If you use a USB extension cable or USB HUB or
USB multi card reader, the USB device may not
be recognized.
• Some USB device may not work with this unit.
• Digital camera and mobile phone are not
supported.
• The USB Port on this unit cannot be connected
to a PC. The unit cannot be used as a storage
device.
• Unformatted media cannot be used. Please
format before using.
• If USB HDD cannot be recognized, try another
dierent USB cable.
• Some USB cables may not supply enough
current for normal USB operation.
• ItisrecommendedtousetheUSBdevicewith
one partition.
• MovieFiles,Musicfilesandphotofilescanbe
played. For details of operations on each file,
refer to relevant pages.
About the external hard disk
drive
The hard disk drive (HDD) is a fragile piece of
equipment. Please use the player following the
guidelines below to protect against possible
HDD failure.
• Do not move the player while it is on.
• Do not use the damaged HDD. Product can be
damaged.
• Install and use a recorder on a stable, level
surface.
• Do not use the recorder in excessively hot or
humid places, or in places that may be subject
to sudden changes in temperature. Sudden
changes in temperature can cause condensation
to form inside the recorder. This can be a cause of
HDD failure.
• While the recorder is switched on, do not unplug
from the wall socket or switch the electricity off
from the breaker switch.
• Do not move the recorder immediately after
switching it off. If you need to move the recorder,
please follow the steps below:
1. After the message “OFF” is shown in the
display, wait at least two minutes.
2. Unplug from the wall socket.
3. Move the player.
• If there’s a power failure while the recorder is on,
there is a chance that some data on the HDD will
be lost.
• The HDD is very delicate. If used improperly or
in an unsuitable environment, it is possible that
the HDD will fail after a few years of use. Signs
of problems include playback unexpectedly
freezing and noticeable block noise (mosaic) in
the picture.
However, sometimes there will be no warning
signs of HDD failure.
• If the HDD fails, playback of recorded material will
not be possible. In this case it will be necessary to
replace the HDD.
• The manufacturer disclaims responsibility for loss
of data contained in HDD.
• It is strongly recommended to use SATA standard
HDD of makers as below for the HDD.
(Seagate, Western Digital, Hitachi, Samsung)