OPERATING INSTRUCTIONS - 1.2 Laney CUB 0 POWER TO THE MUSIC LANEY AMPLIFICATION w w w. l a n e y. c o .
0 CUB Page 2 / 16 Laney IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electrical products, basic cautions should always be followed, including the following: 1. Read these instructions. 2. Keep these instructions safe. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any of the ventilation openings. Install in accordance with manufacturer’s instructions. 8.
ATTENTION: L’utilisation de tout appareil électrique doit être soumise aux precautions d’usage incluant: 1. Lire ces instructions 2. Gardez ce manuel pour de futures références. 3. Prétez attention aux messages de précautions de ce manuel. 4. Suivez ces instructions. 5. N’utilisez pas cette unité proche de plans d’eau. 6. N’utilisez qu’un tissu sec pour le nettoyage de votre unité. 7.
0 CUB Page 4 / 16 Laney WICHTIGE SICHERHEITSHINWEISE - DEUSCH ACHTUNG: Beim Einsatz von Elektrogeräten müssen u.a. grundlegende Vorsichtsmaßnahmen befolgt werden: 1. Lesen Sie sich diese Anweisungen durch. 2. Bewahren Sie diese Anweisungen auf. 3. Beachten Sie alle Warnungen. 4. Befolgen Sie alle Anweisungen. 5. Setzen Sie dieses Gerät nicht in der Nähe von Wasser ein. 6. Reinigen Sie es nur mit einem trockenen Tuch. 7. Blockieren Sie keine der Lüftungsöffnungen.
1. Lea estas instrucciones. 2. Guarde estas instrucciones. 3. Haga caso de todos los consejos. 4. Siga todas las instrucciones. 5. No usar este aparato cerca del agua. 6. Limpiar solamente con una tela seca. 7. No bloquear ninguna de las salidas de ventilación. Instalar de acuerdo a las instrucciones del fabricante. 8. No instalar cerca de ninguna fuente de calor como radiadores, estufas, hornos u otros aparatos (incluyendo amplificadores) que produzcan calor. 9.
0 CUB Laney Intended to alert the user to the presence of uninsulated ‘Dangerous Voltage’ within the products enclosure that may be sufficient to constitute a risk of electrical shock to persons. Ce symbole est utililise pur indiquer a l’utilisateur de ce produit de tension non-isolee dangereuse pouvant etre d’intensite suffisante pour constituer un risque de choc electrique.
~100V, ~115V, ~220V, ~230V, 50/60Hz Operating voltage Factory set 50W 10W Celestion Custom Driver 8 Ohm Extension speaker socket (Disconnects Internal speaker) (8 - 16 Ohm Impedance) Class A/B Push/Pull circuitry 2x6V6GT Power Tubes 2xECC83/12AX7 Preamp Tubes Gain, Tone & Volume Controls Hi & Lo Gain Inputs 1MOhm 355*365*220 8.25 Kg (Shipping Weight 9.
0 CUB Laney Dear Player, Thank you very much for purchasing your new Laney product and becoming part of the worldwide Laney family. Each and every Laney unit is designed and built with the utmost attention to care and detail, so I trust yours will give you many years of enjoyment. Laney products have a heritage which stretches back to 1967 when I first began building valve amplifiers in my parent’s garage.
The Cub-10 is a straight forward easy to use tube combo amplifier, featuring 2 x ECC83/12AX7 preamp tubes and 2 x 6V6GT output tubes. 0 Laney CUB INTRODUCTION Its 10W Class A/B Push/Pull circuitry pumps out classic tube tones through a 10" Celestion speaker. The Chocolate Brown front panel features vintage style and simplicity. After flicking ON the chrome toggle switch, set the tone and volume controls, wind up the gain and you are ready to Rock.
0 CUB Laney 1 2 TOUR OF THE CONTROLS & FEATURES POWER SWITCH: Main power switch for the unit. Tube amplifiers take between 30 seconds and 2 minutes to warm up and be ready to play after switching on, this is normal. POWER INDICATOR: This lamp will be lit when the amplifier is switched on. TONE: The tone control works in a similar fashion to the Tone control you probably have on your guitar except that it 3 uniquely works at the other end of the amplification chain.
8 MAINS LEAD: The mains lead is permanently attached so that it does not get lost or forgotten when you transport your amp. Stow it in the straps provided when not in use to avoid damage. 0 CUB Laney 10 (Always switch off and disconnect the power cord when not in use) 9 SERIAL NO: Displays the model details and serial number of the unit. 10 HANDLE: Laney soft grip handle for comfortable transportation. SERIAL NO.
0 CUB Laney TUBE AMPLIFIER SURVIVAL TIPS • Tube amplifiers; generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect due to the fragile glass tubes themselves. The Cub-10 uses top quality tubes, which should give you years of trouble free service, however like all tube amps; it is important to treat it with a certain amount of care.
underside of the amplifier chassis. The preamp tube is retained by a wire clip, ease this away from the tube and tube can then be gently pulled out. The output tube has a spring retainer which must be pulled away before the tube will come out, see photo opposite. (Removal of both tubes can be eased by applying a slight rocking motion as they are pulled, but ensure that it is only slight, as the plastic location peg on the 6V6GT can easily be damaged).
0 CUB Laney SAMPLE SET UP GS412IA Laney GS412IA Model Power Rating 320W Input Link Serial Number: Designed in the UK by Laney Rock alone... Page 14 / 16 16 Ohms ...
0 Laney CUB NOTES Page 15 / 16
Laney POWER TO THE MUSIC LANEY AMPLIFICATION w w w. l a n e y. c o . u k In the interest of continued product development, Laney reserves the right to amend product specification without prior notification.
