Operation Manual

LANCOM GS-1224 and LANCOM GS-1224P
쮿 Chapter 2: Installation
11
EN
C
Please be aware that LANmonitor shows far more information about
the status of the LANCOM Switch than the LEDs '→ Monitoring the
LANCOM switch with LANmonitor'.
2.3.1 Connectors, LEDs and buttons on the LANCOM GS-1224
Located on the front of the device are connectors for different cabletypes,
light-emitting diodes (LEDs) that provide information on device status, and
also a button.
쐃 POWER LED
Constant green when power is supplied to the device.
쐇
LINK / ACT LED
Port 1 to 24
쮿 Constant green when the network connection is established to the con-
nected device.
쮿 Blinks during data transfer.
쮿 Off if no network connection can be established to the connected device.
쐋
10/100/1000
Mbps LED
쮿 Constant green when the 1000 Mbps mode is active.
쮿 Constant orange when the 100 Mbps mode is active.
쮿 Off when the 10 Mbps is active.
쐏
SFP (LINK/ACT)
LED
쮿 Constant green when the network connection is established to the con-
nected device.
쮿 Blinks during data transfer.
쮿 Off if no network connection can be established to the connected device.
쐄
Reset
Button to reset the system. If you press the button longer than three seconds,
all settings will be reset to default (factory setting).
D
The device starts after the reset in an unconfigured mode and all set-
tings will get lost. Therefore you should save the actual configuration
before you reset the device!
쐂
TP connectors
Connectors for twisted-pair cables.
쐆
SFP connec-
tors
Connectors for small form-factor pluggable (SFP) modules.
쐃쐇 쐋
쐏


