Operation Manual

LANCOM 7011 VPN – LANCOM 8011 VPN

왘 Chapter 3: Basic configuration

3.1.5 Connect charge protection

Connect charge protection blocks connections that go beyond a previously set

amount, protecting you from unexpectedly high connection costs.

In LANCOM VPN, there are three independent budgets: For DSL access, you

can set a maximum connection time in minutes. In addition to this time

budget, there is also a budget for limiting ISDN connection charges.

In order for the limitations according to connect charge rates to func-

tion properly, it is necessary to enter the information for connect

charge rates through ISDN.

Any budget can be deactivated by entering the value '0'.

It is possible to completely turn off connect charge protection

3.2 Instructions for LANconfig

 Start up LANconfig by clicking Start 왘 Programs 왘 LANCOM 왘

LANconfig

LANconfig automatically detects the new LANCOM VPN in the TCP/IP net-

work. Then the setup wizard starts that will help you make the basic set-

tings of the device or will even do all the work for you (provided a suitable

network environment exists).

If the setup wizard does not start automatically, start a manual search

for new devices on all ports (if the LANCOM VPN is connected via a

serial port) or in the network (Device 왘 Find).

If you cannot access an unconfigured LANCOM VPN, the problem may

be due to the netmask of the LAN: with less than 254 possible hosts