User's Guide
Table Of Contents
- Kronos InTouch® DX User Guide: Workforce Dimensions™
- Contents
- Overview
- Employee Mode Transactions
- Introduction
- Access your Individual home page
- Standard transactions
- Smart View transactions
- Edit Paycode (Smart View)
- Message Center (Smart View)
- Move Paycode (Smart View)
- Request Open Shift (Smart View)
- Request Shift Swap (Smart View)
- Respond to Shift Swap Request (Smart View)
- View Accruals (Smart View)
- View My Time (Smart View)
- View Schedule (Smart View)
- View Timecard (Smart View)
- View Totals (Smart View)
- Manager Mode Transactions
- Maintenance Mode Functions
- Troubleshooting
Chapter 4 Maintenance Mode Functions
124
3. To select the employee, use one of the following methods:
– Swipe the employee’s badge.
– Enter the employee’s badge ID.
– Search by employee name.
– Browse the employee list.
4. Direct the employee to place the appropriate finger on the sensor, using the
same position that was used during the initial enrollment.
If the timeclock accepts the verification, a confirmation message appears.
If the verification fails, an error message appears. Tap Retry and instruct the
employee to repeat the verification process. If the verification repeatedly fails,
re-enroll the employee’s finger. See “Biometric transactions: Kronos Touch
ID Plus” on page 65.
Configure Smartcard Reader
1. Tap Edit Advanced Settings.
2. Place the configuration card within two inches of the reader.
3. Tap Continue.